How to Check a Water Heater Element: A Comprehensive Guide
Your water heater is a hardworking appliance, providing hot water for your showers, dishes, and laundry. Over time, its heating elements can wear out, leading to inefficient heating or no hot water at all. Checking your water heater element regularly can help you identify potential issues early, saving you money and inconvenience. Here's a step-by-step guide on how to check a water heater element.
Understanding Your Water Heater Element
Before we dive into the checking process, let's understand what a water heater element is. It's a heating element that heats the water in your tank. There are two types of elements: upper and lower. The upper element heats the water at the top of the tank, while the lower element heats the water at the bottom. Both elements can fail, so it's essential to check both.
Tools You'll Need
- Voltage tester
- Screwdriver (flathead or Phillips, depending on your model)
- Pliers
- Rubber gloves
- Old towel or rag
Checking the Water Heater Element
Step 1: Turn Off the Power and Water
Safety first! Before you start, turn off the power to your water heater at the circuit breaker. Then, turn off the cold water supply valve located at the top of the tank. This will prevent any water from entering the tank while you're working.

Step 2: Drain the Tank
Place a bucket under the drain valve at the bottom of the tank. Open the valve and allow the tank to drain until it's empty. This will make it easier to access the heating elements.
Step 3: Remove the Access Panel
Using a screwdriver, remove the access panel on the side of the tank. This will give you access to the heating elements.
Step 4: Check the Upper Element
Locate the upper element. It's usually at the top of the tank. Use a voltage tester to check if there's power going to the element. If the tester doesn't light up, the element is likely faulty. To confirm, remove the wires from the element and test them again. If they light up, the element is at fault.

Step 5: Check the Lower Element
Follow the same process to check the lower element. It's located at the bottom of the tank. If the element or both elements are faulty, they'll need to be replaced.
Replacing the Water Heater Element
If you've determined that your water heater element needs to be replaced, the process is relatively straightforward. First, ensure the tank is completely drained. Then, unscrew the element using pliers. You may need to use a wrench to loosen it if it's stuck. Once the element is loose, pull it out and replace it with a new one. Make sure to replace it with the same type and size. Reassemble the tank and turn the power and water back on.
When to Call a Professional
While checking and replacing a water heater element can be a DIY task, it's not always recommended. If you're unsure about any part of the process, or if you have an electric water heater with a thermostat, it's best to call a professional. They have the knowledge and tools to handle the job safely and efficiently.
Regular maintenance of your water heater can help extend its lifespan and prevent unexpected breakdowns. Checking the heating elements is a crucial part of this maintenance. So, don't wait until you're left without hot water. Check your water heater elements today!