- Each port registers the and then uses the mac address of client device. You can go-to the configuration page using browser and go to status tab -->Local Network-->DHCP Client Table.
1. Log in to the Linksys Dual-Band WiFi Router web interface. 2. Click the Configuration tab. 3. Click Wi-Fi. 4. Click Wireless MAC Filter. 5. Check the box before the Wireless MAC Filter to enable the feature. Then, select the desired MAC filtering setup option. You can select either: Prevent the PCs listed below from accessing the wireless network. - The wireless devices on the MAC Address Filter List will not have access to the WiFi.
Click Save Settings at the bottom of the page to apply the changes. ... Open a web browser and connect to http://www.linksyssmartwifi.com. Log into your Linksys Smart Wi-Fi account. Under Router Settings select Wireless or Wi-Fi Settings and go to the MAC Filtering tab.
- If your setup interface is the same as with my Linksys WRT54G, all you need to do is go to the config page, click on "MAC Address Clone" (the exact address should be http://192.168.1.1/WanMAC.htm ), and enter your other router's MAC address in there.
If MAC Filtering is configured on the main wireless router, you need to add the MAC address of the Linksys WAP1200AC AC1200 Wi-Fi Access Point to the list of the routers allowed addresses. This is to allow or prevent the Linksys WAP1200AC from connecting to your wireless network.
If your ISP requires a specific MAC address for your network but you want to use a different device, or you just want to change LINKSYS Router MAC Address, then this guide may prove useful to you.
Open a web browser and enter the default IP address ("192.168.1.1") or "myrouter.local" in the Address bar. Then, enter the router password (default is "admin"), and click Log in. ... Make sure that your Connection Type is set to Automatic Configuration - DHCP. ... This step is typically unnecessary, but if your ISP uses a cable connection, you may need to enable MAC Address Clone.
