Replacing exterior wood trim can significantly enhance your home's curb appeal and protect it from weather damage. Over time, wood trim can peel, crack, or become infested, necessitating replacement. This guide walks you through the step-by-step process of how to replace exterior wood trim, ensuring a professional, long-lasting result.

Before embarking on this project, familiarize yourself with the tools you'll need. You'll require a miter saw, jigsaw, drill, pry bar, tape measure, level, sandpaper, and a caulk gun. Additionally, ensure you have the right type and amount of lumber, paint, and caulk for your project.

Removing Old Trim
Begin by safely removing the old trim. Start at a corner and use your pry bar to carefully pry the trim from the wall. Work in small sections at a time to prevent breaking the trim. Remove any nails or screws left behind using your reciprocating saw or drill.

Take measurements of each piece you remove for use as a template when cutting your new trim. Include the miter angles in your measurements to ensure precise cuts.
Cutting and Installing New Trim

Before proceeding, ensure your new lumber is kiln-dried to minimize future warping or cracking. Start by cutting the miters on your new trim pieces using a miter saw. Angle the cut based on your measurements and the direction of the trim. Use a scrap piece of trim to practice and fine-tune your angles.
Installing Individual Pieces
Once you've cut all your pieces, apply a bead of paintable caulk along the back edge of each trim piece. This helps create a tight seal against the wall, which can help prevent water intrusion and improve air sealing.

Apply your trim using a combination of finish nails and construction adhesive. Secure each piece first using nails, ensuring it's level and plumb. Add a bead of construction adhesive along the back of the piece before nailing it in place. Hold the trim in place for 30 seconds to allow the adhesive to set.
Cutting Inside Corners
For inside corners, you can't simply cut a 45-degree miter. You'll need to make a compound miter cut to match the wall angle. Use your miter saw to make the main cut, then use a jigsaw to cut out the waste, following your measured line.

Dry fit your corner pieces before nailing them into place. Adjust as needed to ensure a snug fit. Once satisfied, apply your finish nails and construction adhesive, and hold the piece in place for 30 seconds.
Sanding and Painting









After installing all your trim, sand any rough or uneven edges using 100-grit sandpaper. Wear a dust mask to protect your lungs. Wipe away any sawdust with a damp cloth.
Now you're ready to paint. Use a high-quality exterior paint and primer in one. Begin at the top and work your way down to avoid drips. Paint both sides of the trim and around any nails or screws for a seamless look.
Congratulations! You've successfully replaced your exterior wood trim. Regularly inspect your trim for peeling paint or signs of water damage to catch any issues early. Considering updating your home's exterior every 5-10 years to maintain its appearance and value.