gyroscope_angle
===============
**Source code:** `gyroscope_angle.py <https://chromium.googlesource.com/chromiumos/platform/factory/+/refs/heads/main/py/test/pytests/gyroscope_angle.py>`_

A factory test for gyroscopes.

Description
-----------
There are steps required to run a complete gyroscope test::
  - Motion sensor setup via `ectool motionsense odr ${gyro_id} ${freq}`
  - (optional) Calibration for tri-axis (x, y, and z) gyroscopes.
  - The main gyroscope test.

This pytest executes the motion sensor setup and main gyro test in sequence.

Test Procedure
--------------
This test supports and enables auto start by default.  In this case:

1. Put the device (base/lid) on a static plane then press space.
2. Wait for completion.

Otherwise operators will be asked to place DUT on a horizontal plane and
press space.

Dependency
----------
- Device API (``cros.factory.device.gyroscope``).

Examples
--------
To run the test on base gyroscope:

.. test_list::

  generic_ec_component_accel_examples:AccelerometerIMUTests.GyroscopeAngle



Test Arguments
--------------
.. list-table::
   :widths: 20 10 60
   :header-rows: 1
   :align: left

   * - Name
     - Type
     - Description

   * - rotation_threshold
     - int
     - (optional; default: ``90``) The expected rotating degree for the dut to reach during rotation.

   * - stop_threshold
     - float
     - The expected value to read when dut stop moving.

   * - gyro_id
     - int, None
     - (optional; default: ``None``) Gyroscope ID.  Will read a default ID via ectool if not set.

   * - freq
     - int, None
     - (optional; default: ``None``) Gyroscope sampling frequency in mHz.  Will apply the minimal frequency from ectool info if not set.

   * - timeout_secs
     - int
     - (optional; default: ``60``) Timeout in seconds for gyro to return expected value.

   * - setup_time_secs
     - int
     - (optional; default: ``2``) Seconds to wait before starting the test.

   * - autostart
     - bool
     - (optional; default: ``False``) Auto start this test.

   * - setup_sensor
     - bool
     - (optional; default: ``True``) Setup gyro sensor via ectool

   * - location
     - ['base', 'lid']
     - (optional; default: ``'base'``) Gyro is located in "base" or "lid".

   * - capture_count
     - int
     - (optional; default: ``40``) How many records to read for each time getting data

   * - sample_rate
     - int
     - (optional; default: ``200``) Sample rate in Hz to read data from sensors