The curiosity about the absence of certain technologies or concepts often reveals fascinating insights into human history and technological advancements. One such curiosity is the apparent gap in our battery naming convention, with no 'A' or 'B' in the sequence of AA, AAA, and so on. Let's delve into the world of batteries to understand why this is the case.

Battery naming conventions, like many other standards, have evolved over time and are governed by international bodies. In the case of batteries, the International Electrotechnical Commission (IEC) is responsible for these naming standards. So, why don't we have 'A' or 'B' batteries?

History of Battery Naming
The history of battery naming traces back to the early 20th century when dry cell batteries were first introduced. These batteries were cylindrical cells, and their size was measured in fractions of an inch. The most common sizes were '1/2 C' and '1/3 C', referring to their diameter.

However, as these batteries were used in a wide range of devices, the IPC (Institute of Radio Engineers, later merged with IEEE) decided to standardize the naming convention in 1947. They simplified the names by removing the 'C' and just using the fraction as the suffix, resulting in sizes like 'AA' (1/2 inch) and 'AAA' (1/3 inch) that we're familiar with today.
Why No 'A' Battery?

The 'A' battery, or 1/2 A as it would be, refers to a battery with a diameter of 1/2 inch. Interestingly, these were the largest size of dry cell batteries at one point. However, with the advent of alkaline batteries, which are more efficient and longer-lasting, the smaller 'AA' size became more popular. As a result, 'A' batteries became less common and eventually phased out.
Today, you may still find 'A' batteries in some specialized devices, but they're not widely used. The international battery standard, set by the IEC, doesn't include 'A' batteries because they're considered outdated and have been replaced by more efficient sizes.
Why No 'B' Battery?

The 'B' battery, or 1/3 B, would refer to a battery with a diameter of 1/3 inch. This size is typically found in small, low-drain devices like watches, calculators, or tiny sensors. Rather than using the 'B' nomenclature, these batteries are often referred to as '10' or '1604' batteries due to their typical dimensions.
Again, the IEC standard doesn't include 'B' batteries not because they don't exist but because these sizes are not widely used. Using inconsistent naming standards would create confusion, so the IEC opted to leave out less common sizes for simplicity and clarity.
Evolution of Battery Technology

As batteries have evolved, so have their sizes and shapes. Today, we have not only cylindrical batteries but also flat, coin-like batteries and even soft, thin batteries for wearable devices. The naming convention has also evolved, with codes like 'CR2032' (for a coin cell) and custom names for specialty batteries like '2036' or '2025'.
This evolution underscores how technology and our needs drive the development of standards and naming conventions. As new technologies emerge, we may see further changes in battery naming, but for now, the IEC's standards provide a clear and universal way to identify and categorize batteries.









In the world of battery technology, the absence of 'A' and 'B' batteries may seem like a minor curiosities. However, understanding why they're not part of the IEC's standards provides insight into the evolution of our naming conventions and the advancements in battery technology over the decades.