Repeater Vs Switch at Darnell Williams blog

Repeater Vs Switch. A hub is a multiport repeater in which a signal introduced at the input of any port appears at the output of the all available ports. Directs network traffic based on destination addresses and preset rules. This significantly improves network efficiency and reduces unnecessary traffic. Generally a repeater is used to repeat a signal. Usually used in instances where the distance needed to travel is much longer. They operate above the phy (which handles the wire level. If power is available midspan, a switch may be the cheapest way to go. My biggest factor in this decision would be power. Ethernet repeaters are not completely analogue devices. Switches operate at the data link layer and are more advanced than hubs. These are usually situated between gateways/modems. Unlike hubs that broadcast data to all connected devices, switches intelligently forward data only to the specific device for which it is intended.

A hub is a multiport repeater in which a signal introduced at the input of any port appears at the output of the all available ports. My biggest factor in this decision would be power. Generally a repeater is used to repeat a signal. Usually used in instances where the distance needed to travel is much longer. Switches operate at the data link layer and are more advanced than hubs. These are usually situated between gateways/modems. Ethernet repeaters are not completely analogue devices. They operate above the phy (which handles the wire level. Unlike hubs that broadcast data to all connected devices, switches intelligently forward data only to the specific device for which it is intended. This significantly improves network efficiency and reduces unnecessary traffic.

NETWORK BRIDGE vs REPEATER Detailed Comparison » Network Interview

Repeater Vs Switch Generally a repeater is used to repeat a signal. My biggest factor in this decision would be power. Switches operate at the data link layer and are more advanced than hubs. Directs network traffic based on destination addresses and preset rules. They operate above the phy (which handles the wire level. Ethernet repeaters are not completely analogue devices. Unlike hubs that broadcast data to all connected devices, switches intelligently forward data only to the specific device for which it is intended. Generally a repeater is used to repeat a signal. These are usually situated between gateways/modems. Usually used in instances where the distance needed to travel is much longer. If power is available midspan, a switch may be the cheapest way to go. This significantly improves network efficiency and reduces unnecessary traffic. A hub is a multiport repeater in which a signal introduced at the input of any port appears at the output of the all available ports.