Ford 8.8 Differential Cover Bolt Torque Specs at Ralph Low blog

Ford 8.8 Differential Cover Bolt Torque Specs. From the example above, you can see that the lower line shows the gear ratio, and axle diameter. Apply a tephlon based thread sealer to the threads on the load bolts (you don’t have. It has the 8.8 rear end with 4.10 gears. The axle tag is bolted to the rear differential cover, and is held on with one of the cover bolts. Remove the 10 differential housing cover bolts and drain the lubricant from the axle housing. Anyone know the torque spec for the ten bolts holding on the diff cover of my 2005 ranger. I discussed the locktite issue and torque, and the mechanic said he did and does put loctite on those bolts, with a torque to 60lbs for. Do not overtighten these bolts! Tighten the two load bolts until they make contact with the differential bearing caps. So from that example, we can see that the tag above is a 7.5 inch axle with 3.73 gears.

Do not overtighten these bolts! Remove the 10 differential housing cover bolts and drain the lubricant from the axle housing. Anyone know the torque spec for the ten bolts holding on the diff cover of my 2005 ranger. Apply a tephlon based thread sealer to the threads on the load bolts (you don’t have. From the example above, you can see that the lower line shows the gear ratio, and axle diameter. It has the 8.8 rear end with 4.10 gears. So from that example, we can see that the tag above is a 7.5 inch axle with 3.73 gears. The axle tag is bolted to the rear differential cover, and is held on with one of the cover bolts. Tighten the two load bolts until they make contact with the differential bearing caps. I discussed the locktite issue and torque, and the mechanic said he did and does put loctite on those bolts, with a torque to 60lbs for.

7130KIT Differential Cover, Ford 8.8″ 10Bolt Rear with Gasket

Ford 8.8 Differential Cover Bolt Torque Specs The axle tag is bolted to the rear differential cover, and is held on with one of the cover bolts. Apply a tephlon based thread sealer to the threads on the load bolts (you don’t have. Remove the 10 differential housing cover bolts and drain the lubricant from the axle housing. Tighten the two load bolts until they make contact with the differential bearing caps. It has the 8.8 rear end with 4.10 gears. So from that example, we can see that the tag above is a 7.5 inch axle with 3.73 gears. Anyone know the torque spec for the ten bolts holding on the diff cover of my 2005 ranger. The axle tag is bolted to the rear differential cover, and is held on with one of the cover bolts. From the example above, you can see that the lower line shows the gear ratio, and axle diameter. I discussed the locktite issue and torque, and the mechanic said he did and does put loctite on those bolts, with a torque to 60lbs for. Do not overtighten these bolts!