Sch Cutter Bar Reviews at Stephanie Felder blog

Sch Cutter Bar Reviews. I have no experience with it, and it does cost some coin, but is supposed to be pretty good and a lot less maintenance and hassle (easier adjusted as well), and supposedly better cutting. We purchased a macdon 5010 swing haybine in 1999, with in 2. The cutterbar is so much quieter and vibration free than the. Especially with a new cutterbar. I think it cuts good the way it is and it cuts close enough. When we went to a 25' head you. I have a 25' cih 1020 i am concidering for a sch cutter bar system. I read all these rave reviews about the sch knife and i get tempted to try one again but still have the bad taste in my mouth from. It was cutting rather high. Had an sch on a 1020 20' for years and was near flawless. I put an sch on my 1020 last year and i wasn't real happy about the cut. I have the sch with roller guides on my 973 new holland 20'. Look into the sch cutter bar system too. The roller guides are absolutely reliable, haven't changed one yet. It replaced the 1 1/2 cut factory setup so can't really compare mine to.

Had an sch on a 1020 20' for years and was near flawless. The cutterbar is so much quieter and vibration free than the. The roller guides are absolutely reliable, haven't changed one yet. I put an sch on my 1020 last year and i wasn't real happy about the cut. I think it cuts good the way it is and it cuts close enough. When we went to a 25' head you. Sch is a great addition to any machine that uses a sickle bar. It replaced the 1 1/2 cut factory setup so can't really compare mine to. It was cutting rather high. I should have added this and totally agree.

SCH Grain/Flex Header Cutter Bar System BigIron Auctions

Sch Cutter Bar Reviews I have no experience with it, and it does cost some coin, but is supposed to be pretty good and a lot less maintenance and hassle (easier adjusted as well), and supposedly better cutting. We purchased a macdon 5010 swing haybine in 1999, with in 2. Look into the sch cutter bar system too. I put an sch on my 1020 last year and i wasn't real happy about the cut. I think it cuts good the way it is and it cuts close enough. I read all these rave reviews about the sch knife and i get tempted to try one again but still have the bad taste in my mouth from. I have a 25' cih 1020 i am concidering for a sch cutter bar system. Especially with a new cutterbar. The cutterbar is so much quieter and vibration free than the. I should have added this and totally agree. It was cutting rather high. The roller guides are absolutely reliable, haven't changed one yet. When we went to a 25' head you. I have the sch with roller guides on my 973 new holland 20'. Had an sch on a 1020 20' for years and was near flawless. It replaced the 1 1/2 cut factory setup so can't really compare mine to.