Drill And Tap Intake Manifold at Melinda Thompson blog

Drill And Tap Intake Manifold. Dill and tap intake manifold. The plan is to drill and tap for the 1/4 ntp barbed fitting from my hardware store. I may have to add another 1/2 npt port in the coolant passage on my victor torker ii intake manifold. I need to drill and tap a new hole in the front coolant passage of my intake. You should not drill and tap a intake manifold anywhere unless there is a casting boss in the intake manifold that is thick enough for. I would rather not use a aftermarket intake and id rather. One would be to drill thru the intake and through tap the threads, use a threaded rod and use it as a stud for dist hold down. What is the best tool to. I will drain the antifreeze out about half way and then start tapping like malibu ss 64 did. I would like to drill with the intake manifold in place. Anybody drill and tap there intake manifold for a extra temp sending unit? Any neat ideas for drilling. Stop me if this is the wrong thing to do, guys.

I may have to add another 1/2 npt port in the coolant passage on my victor torker ii intake manifold. I would rather not use a aftermarket intake and id rather. The plan is to drill and tap for the 1/4 ntp barbed fitting from my hardware store. I would like to drill with the intake manifold in place. Dill and tap intake manifold. What is the best tool to. Stop me if this is the wrong thing to do, guys. Any neat ideas for drilling. I need to drill and tap a new hole in the front coolant passage of my intake. You should not drill and tap a intake manifold anywhere unless there is a casting boss in the intake manifold that is thick enough for.

EA888.3 Intake Manifold Boost Tap Kit

Drill And Tap Intake Manifold The plan is to drill and tap for the 1/4 ntp barbed fitting from my hardware store. One would be to drill thru the intake and through tap the threads, use a threaded rod and use it as a stud for dist hold down. I may have to add another 1/2 npt port in the coolant passage on my victor torker ii intake manifold. I would rather not use a aftermarket intake and id rather. I need to drill and tap a new hole in the front coolant passage of my intake. Stop me if this is the wrong thing to do, guys. The plan is to drill and tap for the 1/4 ntp barbed fitting from my hardware store. Anybody drill and tap there intake manifold for a extra temp sending unit? You should not drill and tap a intake manifold anywhere unless there is a casting boss in the intake manifold that is thick enough for. I would like to drill with the intake manifold in place. Dill and tap intake manifold. Any neat ideas for drilling. What is the best tool to. I will drain the antifreeze out about half way and then start tapping like malibu ss 64 did.