Traxxas Revo 3.3 Wont Move at Cory Rosen blog

Traxxas Revo 3.3 Wont Move. It won’t consistently shift without assistance. Sometimes the traxxas revo 3.3 or slayer pro will rev and barely move. Also make sure the slipper clutch is not loose and slipping. I have a revo 3.3 i just put a brand new motor on and it won’t move my transmission and slipper clutch appear to be fine so i’m. I think my reverse micro servo is shot. My r/c revo 3.3, model 5309, will not reverse. 1st the servos are cheap (even traxxas admits it when i called) check to see if the. I found its almost always one of two things. Or it may simply not move. A loose or stripped spur gear will prevent the truck from moving when the motor revs up. It goes fine in drive in both gears, but when i put in in reverse it will just spin, and will. Looking for some advice troubleshooting my revo 3.3: I have a nitro traxxas nitro 4tec 3.3 and i've had to replace the motor and set the gear mesh to tight and it wouldn't move. When i start the truck the little gear below the spur gear just spins, but does not lock into the spur gear to move the truck.

I found its almost always one of two things. My r/c revo 3.3, model 5309, will not reverse. 1st the servos are cheap (even traxxas admits it when i called) check to see if the. Or it may simply not move. A loose or stripped spur gear will prevent the truck from moving when the motor revs up. It goes fine in drive in both gears, but when i put in in reverse it will just spin, and will. I have a revo 3.3 i just put a brand new motor on and it won’t move my transmission and slipper clutch appear to be fine so i’m. I have a nitro traxxas nitro 4tec 3.3 and i've had to replace the motor and set the gear mesh to tight and it wouldn't move. Also make sure the slipper clutch is not loose and slipping. Sometimes the traxxas revo 3.3 or slayer pro will rev and barely move.

Traxxas Revo 3.3 Upgraded R/C Tech Forums

Traxxas Revo 3.3 Wont Move I have a revo 3.3 i just put a brand new motor on and it won’t move my transmission and slipper clutch appear to be fine so i’m. A loose or stripped spur gear will prevent the truck from moving when the motor revs up. I found its almost always one of two things. When i start the truck the little gear below the spur gear just spins, but does not lock into the spur gear to move the truck. I have a nitro traxxas nitro 4tec 3.3 and i've had to replace the motor and set the gear mesh to tight and it wouldn't move. It won’t consistently shift without assistance. It goes fine in drive in both gears, but when i put in in reverse it will just spin, and will. Sometimes the traxxas revo 3.3 or slayer pro will rev and barely move. I have a revo 3.3 i just put a brand new motor on and it won’t move my transmission and slipper clutch appear to be fine so i’m. I think my reverse micro servo is shot. My r/c revo 3.3, model 5309, will not reverse. Looking for some advice troubleshooting my revo 3.3: Or it may simply not move. Also make sure the slipper clutch is not loose and slipping. 1st the servos are cheap (even traxxas admits it when i called) check to see if the.