{
  "affected": [
    {
      "ecosystem_specific": {
        "urgency": "not yet assigned"
      },
      "package": {
        "ecosystem": "Debian:12",
        "name": "linux"
      },
      "ranges": [
        {
          "events": [
            {
              "introduced": "0"
            },
            {
              "fixed": "6.1.180-1"
            }
          ],
          "type": "ECOSYSTEM"
        }
      ]
    },
    {
      "ecosystem_specific": {
        "urgency": "not yet assigned"
      },
      "package": {
        "ecosystem": "Debian:13",
        "name": "linux"
      },
      "ranges": [
        {
          "events": [
            {
              "introduced": "0"
            },
            {
              "fixed": "6.12.100-1"
            }
          ],
          "type": "ECOSYSTEM"
        }
      ]
    },
    {
      "ecosystem_specific": {
        "urgency": "not yet assigned"
      },
      "package": {
        "ecosystem": "Debian:14",
        "name": "linux"
      },
      "ranges": [
        {
          "events": [
            {
              "introduced": "0"
            },
            {
              "fixed": "7.1.5-1"
            }
          ],
          "type": "ECOSYSTEM"
        }
      ]
    }
  ],
  "details": "In the Linux kernel, the following vulnerability has been resolved:  flow_dissector: check device type before reading ETH_ADDRS  __skb_flow_dissect() unconditionally reads 12 bytes from eth_hdr(skb) when FLOW_DISSECTOR_KEY_ETH_ADDRS is requested. This assumes the skb has a valid Ethernet header at mac_header, which is not always the case.  The problem can be triggered by:  1. Creating a TUN device in L3 mode (IFF_TUN, hard_header_len=0)  2. Attaching a multiq qdisc with a flower filter matching on eth_src  3. Sending a packet through AF_PACKET  Since TUN in L3 mode has no link-layer header, mac_header points to the L3 data area. The flow dissector reads 12 bytes of uninitialized skb memory, which then propagates through fl_set_masked_key() and is used as a rhashtable lookup key in __fl_lookup(), as reported by KMSAN.  Rejecting the filter in the control path (at tc filter add time) is not feasible because TC filter blocks can be shared between arbitrary devices -- a filter installed on an Ethernet device may later classify packets on a headerless device through a shared block. The device association is not fixed at filter creation time.  Fix this by gating the memcpy on dev-\u003etype == ARPHRD_ETHER, which ensures only true Ethernet-framed packets have their addresses read. This is more precise than the previous hard_header_len \u003e= 12 check, which would incorrectly pass for non-Ethernet link types like IPoIB (ARPHRD_INFINIBAND, hard_header_len=24) and FDDI (hard_header_len=21) whose L2 headers are not in Ethernet format. Additionally check skb_mac_header_was_set() to guard against the pathological case where mac_header is the unset sentinel (~0U), which would cause eth_hdr() to return a wild pointer.  For the act_mirred redirect case (Ethernet packet redirected to a non-Ethernet device sharing a TC block), zeroing the key is the correct behavior: the packet is now being classified on the target device, where Ethernet address matching is not semantically meaningful.  Note: on non-Ethernet devices, the zeroed key will match a filter configured with all-zero MAC addresses. This is an improvement over the previous behavior where uninitialized memory could randomly match any filter.",
  "id": "DEBIAN-CVE-2026-72444",
  "modified": "2026-09-14T16:47:34.687894208Z",
  "published": "2026-08-15T06:22:18.280Z",
  "references": [
    {
      "type": "ADVISORY",
      "url": "https://security-tracker.debian.org/tracker/CVE-2026-72444"
    }
  ],
  "severity": [
    {
      "score": "CVSS:3.1/AV:L/AC:L/PR:L/UI:N/S:U/C:H/I:H/A:H",
      "type": "CVSS_V3"
    }
  ],
  "upstream": [
    "CVE-2026-72444"
  ]
}