{
  "affected": [
    {
      "ecosystem_specific": {
        "urgency": "not yet assigned"
      },
      "package": {
        "ecosystem": "Debian:12",
        "name": "linux"
      },
      "ranges": [
        {
          "events": [
            {
              "introduced": "0"
            }
          ],
          "type": "ECOSYSTEM"
        }
      ]
    },
    {
      "ecosystem_specific": {
        "urgency": "not yet assigned"
      },
      "package": {
        "ecosystem": "Debian:13",
        "name": "linux"
      },
      "ranges": [
        {
          "events": [
            {
              "introduced": "0"
            }
          ],
          "type": "ECOSYSTEM"
        }
      ]
    },
    {
      "ecosystem_specific": {
        "urgency": "not yet assigned"
      },
      "package": {
        "ecosystem": "Debian:14",
        "name": "linux"
      },
      "ranges": [
        {
          "events": [
            {
              "introduced": "0"
            }
          ],
          "type": "ECOSYSTEM"
        }
      ]
    }
  ],
  "details": "In the Linux kernel, the following vulnerability has been resolved:  ASoC: cs35l34: drain threaded IRQ before runtime suspend  cs35l34_runtime_suspend() currently switches the codec into regcache_cache_only(true), asserts reset low, and powers the device off without first quiescing the threaded IRQ registered by devm_request_threaded_irq(). That leaves a window where cs35l34_irq_thread() can still run after suspend has removed live hardware access.  A running system can reach this during runtime PM while the driver still has critical fault IRQs unmasked. If the threaded handler runs in that window, it reads volatile INT_STATUS_1..4 after cache_only has been enabled, ignores the regmap_read() failures, and can still execute the PROT_RELEASE_CTL release sequence or the BST fault power-down writes.  Use disable_irq() before entering cache_only/reset-low/power-off so any in-flight threaded handler is drained and no new IRQ thread can run while the device is suspended. Re-enable the IRQ only after runtime_resume() has restored live register access with regcache_sync(). Since probe only logs request_threaded_irq() failures and keeps going, track whether the IRQ was actually installed before disabling or re-enabling it.",
  "id": "DEBIAN-CVE-2026-89945",
  "modified": "2026-09-17T04:47:34.004482110Z",
  "published": "2026-09-16T11:17:04.383Z",
  "references": [
    {
      "type": "ADVISORY",
      "url": "https://security-tracker.debian.org/tracker/CVE-2026-89945"
    }
  ],
  "upstream": [
    "CVE-2026-89945"
  ]
}