{
  "affected": [
    {
      "ecosystem_specific": {
        "urgency": "not yet assigned"
      },
      "package": {
        "ecosystem": "Debian:12",
        "name": "linux"
      },
      "ranges": [
        {
          "events": [
            {
              "introduced": "0"
            }
          ],
          "type": "ECOSYSTEM"
        }
      ]
    },
    {
      "ecosystem_specific": {
        "urgency": "not yet assigned"
      },
      "package": {
        "ecosystem": "Debian:13",
        "name": "linux"
      },
      "ranges": [
        {
          "events": [
            {
              "introduced": "0"
            }
          ],
          "type": "ECOSYSTEM"
        }
      ]
    },
    {
      "ecosystem_specific": {
        "urgency": "not yet assigned"
      },
      "package": {
        "ecosystem": "Debian:14",
        "name": "linux"
      },
      "ranges": [
        {
          "events": [
            {
              "introduced": "0"
            }
          ],
          "type": "ECOSYSTEM"
        }
      ]
    }
  ],
  "details": "In the Linux kernel, the following vulnerability has been resolved:  dmaengine: xilinx_dma: Fix CPU stall in xilinx_dma_poll_timeout  Currently when calling xilinx_dma_poll_timeout with delay_us=0 and a condition that is never fulfilled, the CPU busy-waits for prolonged time and the timeout triggers only with a massive delay causing a CPU stall.  This happens due to a huge underestimation of wall clock time in poll_timeout_us_atomic. Commit 7349a69cf312 (\"iopoll: Do not use timekeeping in read_poll_timeout_atomic()\") changed the behavior to no longer use ktime_get at the expense of underestimation of wall clock time which appears to be very large for delay_us=0. Instead of timing out after approximately XILINX_DMA_LOOP_COUNT microseconds, the timeout takes XILINX_DMA_LOOP_COUNT * 1000 * (time that the overhead of the for loop in poll_timeout_us_atomic takes) which is in the range of several minutes for XILINX_DMA_LOOP_COUNT=1000000. Fix this by using a non-zero value for delay_us. Use delay_us=10 to keep the delay in the hot path of starting DMA transfers minimal but still avoid CPU stalls in case of unexpected hardware failures.  One-off measurement with delay_us=0 causes the cpu to busy wait around 7 minutes in the timeout case. After applying this patch with delay_us=10 the measured timeout was 1053428 microseconds which is roughly equivalent to the expected 1000000 microseconds specified in XILINX_DMA_LOOP_COUNT.  Add a constant XILINX_DMA_POLL_DELAY_US for delay_us value.",
  "id": "DEBIAN-CVE-2026-93168",
  "modified": "2026-09-18T04:47:41.604974373Z",
  "published": "2026-09-17T17:18:12.403Z",
  "references": [
    {
      "type": "ADVISORY",
      "url": "https://security-tracker.debian.org/tracker/CVE-2026-93168"
    }
  ],
  "upstream": [
    "CVE-2026-93168"
  ]
}