Sbc Fuel Pump Push Rod Stuck at Becky Craig blog

Sbc Fuel Pump Push Rod Stuck. If you are worried that the push rod might fall back down while installing the pump, there is a neat little trick you can use. So, question is can i leave the stock pr where it is, install block off plate and go electric. When we were ready to install the new pump we took a strong magnet and stuck it to the push rod and then bumped the engine over until. Got this friend that changed the fuel pump on his small block chevy (350) and forgot about the push rod. Back in the day when we replaced a sbc fuel pump we didn't really care if the push rod fell down. According to him, he installed the new pump and cranked down. When i crank the car the rod only moves 1/2 in. So, i took off the pump and plate and the fuel pump rod won't come out. Seems like an easier fix. This usually is caused by someone putting to long of bolt in the push rod hole in the front of the block and not noticing. An easy way is to install a tee fitting that has an obstruction (washer) with about 1/8 to 3/16ths inch dia hole on the return line side. The top front motor mount bolt hole goes all the way.

Back in the day when we replaced a sbc fuel pump we didn't really care if the push rod fell down. When we were ready to install the new pump we took a strong magnet and stuck it to the push rod and then bumped the engine over until. So, i took off the pump and plate and the fuel pump rod won't come out. Seems like an easier fix. This usually is caused by someone putting to long of bolt in the push rod hole in the front of the block and not noticing. The top front motor mount bolt hole goes all the way. According to him, he installed the new pump and cranked down. If you are worried that the push rod might fall back down while installing the pump, there is a neat little trick you can use. So, question is can i leave the stock pr where it is, install block off plate and go electric. An easy way is to install a tee fitting that has an obstruction (washer) with about 1/8 to 3/16ths inch dia hole on the return line side.

Technical SBC bent fuel pump rod WTF The H.A.M.B.

Sbc Fuel Pump Push Rod Stuck An easy way is to install a tee fitting that has an obstruction (washer) with about 1/8 to 3/16ths inch dia hole on the return line side. When we were ready to install the new pump we took a strong magnet and stuck it to the push rod and then bumped the engine over until. So, question is can i leave the stock pr where it is, install block off plate and go electric. An easy way is to install a tee fitting that has an obstruction (washer) with about 1/8 to 3/16ths inch dia hole on the return line side. So, i took off the pump and plate and the fuel pump rod won't come out. If you are worried that the push rod might fall back down while installing the pump, there is a neat little trick you can use. When i crank the car the rod only moves 1/2 in. The top front motor mount bolt hole goes all the way. This usually is caused by someone putting to long of bolt in the push rod hole in the front of the block and not noticing. Back in the day when we replaced a sbc fuel pump we didn't really care if the push rod fell down. Got this friend that changed the fuel pump on his small block chevy (350) and forgot about the push rod. Seems like an easier fix. According to him, he installed the new pump and cranked down.