Power Supply Screws Don't Line Up at Karla Ted blog

Power Supply Screws Don't Line Up. If the psu is still not fitting due to the screws from the fan bracket, then you have a few options to consider: Don't tighten the screws down all the way until you have all four at least started. It's thermaltake v21 and thermaltake toughpower 750w modular. Are you sure the psu is in all the way both side way and in the back? The bottom 2 holes line up, the top left fits in one of. If the screws really only go in a tiny bit like in your picture, you most likely have the wrong screws (too big or wrong threading) for some reason. At the most i can get two to line up, but the other end of the psu is not aligned with the back of the case. If you have the fan facing up into the case, that's wrong, and should face towards the bottom where the psu intake fan grill is. I had a problem with my ca obsidian 650d. It will line up better once you get the screws in. That will leave the psu some wiggle room to get. List anything you've done in attempt to.

List anything you've done in attempt to. The bottom 2 holes line up, the top left fits in one of. At the most i can get two to line up, but the other end of the psu is not aligned with the back of the case. If you have the fan facing up into the case, that's wrong, and should face towards the bottom where the psu intake fan grill is. Don't tighten the screws down all the way until you have all four at least started. It's thermaltake v21 and thermaltake toughpower 750w modular. Are you sure the psu is in all the way both side way and in the back? That will leave the psu some wiggle room to get. If the psu is still not fitting due to the screws from the fan bracket, then you have a few options to consider: If the screws really only go in a tiny bit like in your picture, you most likely have the wrong screws (too big or wrong threading) for some reason.

Holes and slots don't line up, how would you attach this ball screw

Power Supply Screws Don't Line Up Are you sure the psu is in all the way both side way and in the back? List anything you've done in attempt to. It will line up better once you get the screws in. Don't tighten the screws down all the way until you have all four at least started. It's thermaltake v21 and thermaltake toughpower 750w modular. If the screws really only go in a tiny bit like in your picture, you most likely have the wrong screws (too big or wrong threading) for some reason. I had a problem with my ca obsidian 650d. At the most i can get two to line up, but the other end of the psu is not aligned with the back of the case. If the psu is still not fitting due to the screws from the fan bracket, then you have a few options to consider: The bottom 2 holes line up, the top left fits in one of. If you have the fan facing up into the case, that's wrong, and should face towards the bottom where the psu intake fan grill is. Are you sure the psu is in all the way both side way and in the back? That will leave the psu some wiggle room to get.