Bmw K100 Gear Indicator

BMW K100, 7 segment gear indicator replacement. The original LCD gear display on K bikes is prone to bleeding out and becoming unreadable. Happened to mine and while it's not really a problem, while I was inside the speedo trying to sort another problem, I thought I'd try to source a replacement.

Time to clean and repot the gear position indicator switch. Do it as part of a full rear end service (swing arm bearings, spline lube, brakes, etc.) The potting compound that was used breaks down and allows water and who. Today when coming home from a ride on my '87 K100RT, low mileage at 283,000 kms, my 1st and 2nd gear indicators have been replaced by the neutral 0.

What is the fix or is this something that will right itself over time? First time that this has ever happened. Would I be correct in guessing some. I replaced my gear indicator switch on my old '83 K100 last year.

If they haven't changed their design too much, I think you'll find the location of the switch more or less the same as the early K75's and K100's. Remove the rear wheel, remove the bevel box (rear drive unit) access your pivot stubs, remove the swingarm and slide out the shaft. K100 Gear Indicator The document details a DIY guide for replacing the LCD gear indicator on a BMW K100 with an LED display due to the original's unreliability.

It outlines the necessary tools, components, and step. The Gear Indicator and Start Enable Board also has circuitry to amplify and condition the speed signal coming off the rear drive. Many modern aftermarket speedometers require the use of an active inductive sensor that outputs large voltage levels (>7 volts) for the meter to work properly.

We wish to replace the gear indicator sender on a BMW K100 rs 1989. If anyone has any information, we require help on carrying this job out. Please post.

The gear indicator is showing #4 in neutral and #5 in first and the neutral green light does not come on in neutral or any other time. The LCD clock is also not working. This is a machine that I bought because it has low mileage 40000KM and had not run since 2009.The bike will be on the road.

Hello, I'm rebuilding my K100rs. After completely cutting of the cockpit and trying to rewire everything I found out that my gear position indicator was broken. K100 Gear indicator.

Jump to Latest 6.6K views 2 replies 2 participants last post by Morley Oct 5, 2008 M.