Governor Linkage Control Rod at Edward Varley blog

Governor Linkage Control Rod. To adjust rod length, disconnect rod from governor lever arm and loosen jam nut. The throttle control rod should be adjusted to obtain. Adjust the carburetor control rod yoke so the pin you removed will freely enter hold governor arm with the carburetor butterfly wide. Set throttle disk in wide open position. The governor link is the blue one and the control link is the red one. My problem is when the throttle control lever is pushed into the start position it is not operating the choke. I can only see one rod from the carb to the governor arm and a light. The throttle plate is linked (#12) directly to the governor arm. This picture highlights where the control link connects. It connects to the rotating control arm on the bottom of the tank bracket. Move speed control lever to the wide open position. Check to see if the governor lever arm rod is long enough so that the throttle control plunger contacts the horizontal. Is obtained in last notch. Control rod, bending the control linkage until 2200 r.p.m. Video showing how the linkages and governor spring is setup on a older style briggs and stratton one piece flow jet carburetor, commonly found.

Move speed control lever to the wide open position. Set throttle disk in wide open position. It connects to the rotating control arm on the bottom of the tank bracket. To adjust rod length, disconnect rod from governor lever arm and loosen jam nut. Is obtained in last notch. Adjust the carburetor control rod yoke so the pin you removed will freely enter hold governor arm with the carburetor butterfly wide. The throttle control rod should be adjusted to obtain. Video showing how the linkages and governor spring is setup on a older style briggs and stratton one piece flow jet carburetor, commonly found. I can only see one rod from the carb to the governor arm and a light. Check to see if the governor lever arm rod is long enough so that the throttle control plunger contacts the horizontal.

Briggs Intek VTwin Throttle and Governor Controls Explained YouTube

Governor Linkage Control Rod Adjust the carburetor control rod yoke so the pin you removed will freely enter hold governor arm with the carburetor butterfly wide. My problem is when the throttle control lever is pushed into the start position it is not operating the choke. The throttle plate is linked (#12) directly to the governor arm. This picture highlights where the control link connects. Move speed control lever to the wide open position. I can only see one rod from the carb to the governor arm and a light. To adjust rod length, disconnect rod from governor lever arm and loosen jam nut. The throttle control rod should be adjusted to obtain. Is obtained in last notch. It connects to the rotating control arm on the bottom of the tank bracket. Adjust the carburetor control rod yoke so the pin you removed will freely enter hold governor arm with the carburetor butterfly wide. Control rod, bending the control linkage until 2200 r.p.m. The governor spring (#13) is linked to the speed selector arm on the. Video showing how the linkages and governor spring is setup on a older style briggs and stratton one piece flow jet carburetor, commonly found. The governor link is the blue one and the control link is the red one. Set throttle disk in wide open position.