Jeep Yj Fuel Sending Unit Ohms at Kathleen Ruth blog

Jeep Yj Fuel Sending Unit Ohms. 1m+ visitors in the past month It is bouncing between 63 ohms up to 75. But like jbolty said, it could. I know the chevy guage ohms are 0 empty and 90 full so you prolly need the one thats 73 empty and 8 to 12 full. I disconnected the sending unit (the pump has been removed) and tested it with my ohm meter. But that shouldn't matter if you are replacing sending unit and gauge, just get them to. The reason it might not work with the gauge and does work with the fuel pump is a matter of ohms law. The level of fuel increases / decreases the. The sending unit should technically be measured in ohms because there is a rheostat in there. The fuel pump ground is common. When i first tested my fuel sender unit i recorded readings between 26 ohms (empty) to 85 ohms (full). If the resistance falls in this ballpark (depending on how much gas you have in the tank), then the sending unit is fine. I have a 95 yj with 4.0l, i am getting ready to stretch it and use a rci 2161a fuel cell, and i was thinking about running an inline fuel pump. The stock gauge reads 0 ohms empty and 80 ohms full. Well i figured it out.

The sending unit should technically be measured in ohms because there is a rheostat in there. The fuel pump ground is common. But that shouldn't matter if you are replacing sending unit and gauge, just get them to. I know the chevy guage ohms are 0 empty and 90 full so you prolly need the one thats 73 empty and 8 to 12 full. When i first tested my fuel sender unit i recorded readings between 26 ohms (empty) to 85 ohms (full). The reason it might not work with the gauge and does work with the fuel pump is a matter of ohms law. The stock gauge reads 0 ohms empty and 80 ohms full. If the resistance falls in this ballpark (depending on how much gas you have in the tank), then the sending unit is fine. I disconnected the sending unit (the pump has been removed) and tested it with my ohm meter. I have a 95 yj with 4.0l, i am getting ready to stretch it and use a rci 2161a fuel cell, and i was thinking about running an inline fuel pump.

19871990 Jeep YJ Wrangler Fuel Sending Unit 20 Gal. Tank

Jeep Yj Fuel Sending Unit Ohms The level of fuel increases / decreases the. It is bouncing between 63 ohms up to 75. If the resistance falls in this ballpark (depending on how much gas you have in the tank), then the sending unit is fine. 1m+ visitors in the past month I know the chevy guage ohms are 0 empty and 90 full so you prolly need the one thats 73 empty and 8 to 12 full. The reason it might not work with the gauge and does work with the fuel pump is a matter of ohms law. Well i figured it out. The stock gauge reads 0 ohms empty and 80 ohms full. The fuel pump ground is common. When i first tested my fuel sender unit i recorded readings between 26 ohms (empty) to 85 ohms (full). I have a 95 yj with 4.0l, i am getting ready to stretch it and use a rci 2161a fuel cell, and i was thinking about running an inline fuel pump. But that shouldn't matter if you are replacing sending unit and gauge, just get them to. But like jbolty said, it could. I disconnected the sending unit (the pump has been removed) and tested it with my ohm meter. The sending unit should technically be measured in ohms because there is a rheostat in there. The level of fuel increases / decreases the.