How To Test A Mercury Relay at Kimberly Helms blog

How To Test A Mercury Relay. Next, listen for the solenoid/start relay while operating the control (tilt) switch up or down. 1.6k views 2 years ago. Be sure to check the wiring to the bottom of the relay sockets for corroded and broken wires! The up and down relays are identical, so switching them back and forth is ok. If you try to raise or lower the engine and nothing happens, first check to make sure that the battery is charged and that the battery switch is in the “on” position. To test the trim relay, you’ll need a multimeter. How to test the mercury outboard trim relay. When switching the relays, see if the problem changes directions. Touch the red probe from your multimeter to each connection point for the relay, and touch the black probe to any known ground. Here’s how to do it: Well if you found where the relays are and have a multimeter or a test lamp you can test the relays and switch on the throttle. Turn off the engine and disconnect the battery.

Next, listen for the solenoid/start relay while operating the control (tilt) switch up or down. 1.6k views 2 years ago. The up and down relays are identical, so switching them back and forth is ok. Be sure to check the wiring to the bottom of the relay sockets for corroded and broken wires! Here’s how to do it: When switching the relays, see if the problem changes directions. Turn off the engine and disconnect the battery. How to test the mercury outboard trim relay. To test the trim relay, you’ll need a multimeter. Well if you found where the relays are and have a multimeter or a test lamp you can test the relays and switch on the throttle.

How To Test Mercury Outboard Rectifier Mercury Drugs

How To Test A Mercury Relay Well if you found where the relays are and have a multimeter or a test lamp you can test the relays and switch on the throttle. The up and down relays are identical, so switching them back and forth is ok. Touch the red probe from your multimeter to each connection point for the relay, and touch the black probe to any known ground. Next, listen for the solenoid/start relay while operating the control (tilt) switch up or down. 1.6k views 2 years ago. Here’s how to do it: If you try to raise or lower the engine and nothing happens, first check to make sure that the battery is charged and that the battery switch is in the “on” position. Turn off the engine and disconnect the battery. Be sure to check the wiring to the bottom of the relay sockets for corroded and broken wires! To test the trim relay, you’ll need a multimeter. How to test the mercury outboard trim relay. Well if you found where the relays are and have a multimeter or a test lamp you can test the relays and switch on the throttle. When switching the relays, see if the problem changes directions.