Ls Swap Fuel Pump Not Working at Harry Leslie blog

Ls Swap Fuel Pump Not Working. I switched the pink/black wire from the. I installed a stand alone harness that was new, and included a fuse and relay panel. There is no power coming in on the dark green/white wire at a8 (relay pin. Pin 86 of the relay will should have power for 5 seconds when you turn the key on, that's fuel pump prime. I directly connected 87 (battery) to 30 (fuel pump control) and the relay clicks but no fuel pump prime. Following all of the instructions below, i have all of the wires i want to use connected. If you do go with the 21 gallon tank, i am not sure the novak fuel pump will work because the 21 gallon tank takes a special. I'm ready to start my truck but i don't seem to be getting any power to the fuel pump. I checked 30 and 85 (my ground) and i. Everything seems to work, except the fuel pump relay. Going to a 700r4 just removes the electronic controls and makes more work for you to try and figure out how to get the tvs cable. The only 2 wires that should have been connected to make the new pump run is the grey wire (+12 volts, relay actuated) and the.

I directly connected 87 (battery) to 30 (fuel pump control) and the relay clicks but no fuel pump prime. There is no power coming in on the dark green/white wire at a8 (relay pin. I installed a stand alone harness that was new, and included a fuse and relay panel. Pin 86 of the relay will should have power for 5 seconds when you turn the key on, that's fuel pump prime. Going to a 700r4 just removes the electronic controls and makes more work for you to try and figure out how to get the tvs cable. Following all of the instructions below, i have all of the wires i want to use connected. I checked 30 and 85 (my ground) and i. Everything seems to work, except the fuel pump relay. If you do go with the 21 gallon tank, i am not sure the novak fuel pump will work because the 21 gallon tank takes a special. I'm ready to start my truck but i don't seem to be getting any power to the fuel pump.

300zx LS swap fuel pump relay wiring YouTube

Ls Swap Fuel Pump Not Working I'm ready to start my truck but i don't seem to be getting any power to the fuel pump. The only 2 wires that should have been connected to make the new pump run is the grey wire (+12 volts, relay actuated) and the. I checked 30 and 85 (my ground) and i. If you do go with the 21 gallon tank, i am not sure the novak fuel pump will work because the 21 gallon tank takes a special. Following all of the instructions below, i have all of the wires i want to use connected. I installed a stand alone harness that was new, and included a fuse and relay panel. Everything seems to work, except the fuel pump relay. There is no power coming in on the dark green/white wire at a8 (relay pin. I'm ready to start my truck but i don't seem to be getting any power to the fuel pump. Pin 86 of the relay will should have power for 5 seconds when you turn the key on, that's fuel pump prime. I switched the pink/black wire from the. I directly connected 87 (battery) to 30 (fuel pump control) and the relay clicks but no fuel pump prime. Going to a 700r4 just removes the electronic controls and makes more work for you to try and figure out how to get the tvs cable.