Revo 3.3 Throttle Servo Not Working at Brigid Mcmichael blog

Revo 3.3 Throttle Servo Not Working. remove the air filter from the carburetor, and then remove the brake rod from the brake lever by loosening the 3x12mm button. If its pulling the throttle wide open or holding it wide open, no amount of tuning.  — it does sound like the carb is stuck open, make sure your linkage is hooked up, also, with only your electronics.  — yeah the gear mesh may be set to tight. This unit is made with dual graphite plates. to mount the throttle servo, i use an extreme racing™ throttle servo mount for the revo.  — spun a front tire so fast that it blew apart! I tried 3 different modules and they all failed and or caused similar.  — i would ask more info, but that throttle linkage setup and spring on the revo causes alot of low to average grade.  — if you swapped channels on your receiver with both servos and the throttle still spent work, its dead.  — i've seem to come across a string of bad luck involving my 3.3 revo's throttle servo.  — about two months ago i lost control of my revo, full throttle and no steering ended up crashing into a curb. The motor inside could is wore out, so when under pressure they.  — what is the throttle servo doing? Now whenever i turn on the car the throttle servo is cool for about 10.

I tried 3 different modules and they all failed and or caused similar.  — about two months ago i lost control of my revo, full throttle and no steering ended up crashing into a curb.  — i would ask more info, but that throttle linkage setup and spring on the revo causes alot of low to average grade. remove the air filter from the carburetor, and then remove the brake rod from the brake lever by loosening the 3x12mm button. to mount the throttle servo, i use an extreme racing™ throttle servo mount for the revo. In the past week i've burned.  — it does sound like the carb is stuck open, make sure your linkage is hooked up, also, with only your electronics.  — spun a front tire so fast that it blew apart! Disconnect the steering links from the. The motor inside could is wore out, so when under pressure they.

Servo setup not working... r/ArduinoProjects

Revo 3.3 Throttle Servo Not Working This unit is made with dual graphite plates. After everything i have been thru with these full throttle issues and finally getting.  — about two months ago i lost control of my revo, full throttle and no steering ended up crashing into a curb. I tried 3 different modules and they all failed and or caused similar. to mount the throttle servo, i use an extreme racing™ throttle servo mount for the revo. If that's not it, reverse the. Now whenever i turn on the car the throttle servo is cool for about 10. remove the servo horns and steering links from the servos.  — bad servos will still work just not as efficiantly.  — you might have the radio antenna too close to the receiver, causing chatter.  — 13k views 6 years ago.  — i've seem to come across a string of bad luck involving my 3.3 revo's throttle servo. i found all my issues with my revo were optidrive related. If its pulling the throttle wide open or holding it wide open, no amount of tuning. remove the air filter from the carburetor, and then remove the brake rod from the brake lever by loosening the 3x12mm button. Hey guys i'm building a 3.3 that i got in parts and i'm doing the final touches with everything before i fire it up.