Chevelle Gas Gauge Reads Full at Jack Belser blog

Chevelle Gas Gauge Reads Full. If you get a good ohm reading, something in range of your sender, then the tan wire has an open somewhere in its length. Easy troubleshooting to isolate if it is the gauge or the sender or the harness. I tested the gauge by leaving the sender wire hang free and. I have a brand new wiring harness in the car, and my fuel gauge goes to full and stays there with only 6 gallons of gas in. There is power going to the gauge, and we have grounded the gauge out at the connector in the trunk leading to the gauge and it doesn't go to. With the tan wire disconnected at the fuel tank, the fuel gauge should read past full with the ignition on. With the tan wire disconnected at the fuel tank,. Hi everyone, my gas gauge is only reading half full when the tank is full. You're looking for a single tan colored wire. Wait a few moments as some. 1) locate the fuel sender feed wire near the fuel tank.

I have a brand new wiring harness in the car, and my fuel gauge goes to full and stays there with only 6 gallons of gas in. Hi everyone, my gas gauge is only reading half full when the tank is full. If you get a good ohm reading, something in range of your sender, then the tan wire has an open somewhere in its length. I tested the gauge by leaving the sender wire hang free and. With the tan wire disconnected at the fuel tank, the fuel gauge should read past full with the ignition on. With the tan wire disconnected at the fuel tank,. Wait a few moments as some. You're looking for a single tan colored wire. There is power going to the gauge, and we have grounded the gauge out at the connector in the trunk leading to the gauge and it doesn't go to. Easy troubleshooting to isolate if it is the gauge or the sender or the harness.

19712 Chevelle El Camino Fuel Gauge Sundellauto Specialties

Chevelle Gas Gauge Reads Full 1) locate the fuel sender feed wire near the fuel tank. I have a brand new wiring harness in the car, and my fuel gauge goes to full and stays there with only 6 gallons of gas in. 1) locate the fuel sender feed wire near the fuel tank. You're looking for a single tan colored wire. With the tan wire disconnected at the fuel tank,. Hi everyone, my gas gauge is only reading half full when the tank is full. Easy troubleshooting to isolate if it is the gauge or the sender or the harness. With the tan wire disconnected at the fuel tank, the fuel gauge should read past full with the ignition on. Wait a few moments as some. I tested the gauge by leaving the sender wire hang free and. If you get a good ohm reading, something in range of your sender, then the tan wire has an open somewhere in its length. There is power going to the gauge, and we have grounded the gauge out at the connector in the trunk leading to the gauge and it doesn't go to.