Mallory Unilite Coil Resistance at Zoe Agaundo blog

Mallory Unilite Coil Resistance. Turn the ignition on and test voltage at the negative side of the coil (black lead of meter to ground and red lead of meter to coil. The mallory module needs at least 2 ohms of resistance for. When the key is released. However, they do have different amounts of primary resistance, which is measured in ohms. When the key is in the cranking position, the ballast is bypassed, feeding the full 12 volts to the coil. All unilite distributors need coils with a minimum amount of 1.4 ohms primary resistance. The unilite module does require a ballast resistor. You need around 1.5 ohms on the primary of the coil. The mallory coil has a primary resistance of 1.4 ohms of resistance. However, ballast resistors are a better way of keeping the voltage constant. You must use a stock coil with the. You can still use a coil with less than 1.4 ohms, but you must install a ballast resistor (mallory #700) between the coil and the distributor. You must use a ballast resistor between the coil and the mallory unilite led module. Unilitefi test procedure 1) remove the cap and rotor.

The mallory coil has a primary resistance of 1.4 ohms of resistance. Turn the ignition on and test voltage at the negative side of the coil (black lead of meter to ground and red lead of meter to coil. However, ballast resistors are a better way of keeping the voltage constant. Unilitefi test procedure 1) remove the cap and rotor. The mallory module needs at least 2 ohms of resistance for. You can still use a coil with less than 1.4 ohms, but you must install a ballast resistor (mallory #700) between the coil and the distributor. You must use a stock coil with the. However, they do have different amounts of primary resistance, which is measured in ohms. When the key is in the cranking position, the ballast is bypassed, feeding the full 12 volts to the coil. When the key is released.

Mallory 3758001 Unilite Distributor, Pontiac 301455

Mallory Unilite Coil Resistance All unilite distributors need coils with a minimum amount of 1.4 ohms primary resistance. The mallory module needs at least 2 ohms of resistance for. The mallory coil has a primary resistance of 1.4 ohms of resistance. You must use a ballast resistor between the coil and the mallory unilite led module. However, they do have different amounts of primary resistance, which is measured in ohms. Turn the ignition on and test voltage at the negative side of the coil (black lead of meter to ground and red lead of meter to coil. However, ballast resistors are a better way of keeping the voltage constant. When the key is released. The unilite module does require a ballast resistor. You need around 1.5 ohms on the primary of the coil. You can still use a coil with less than 1.4 ohms, but you must install a ballast resistor (mallory #700) between the coil and the distributor. You must use a stock coil with the. When the key is in the cranking position, the ballast is bypassed, feeding the full 12 volts to the coil. Unilitefi test procedure 1) remove the cap and rotor. All unilite distributors need coils with a minimum amount of 1.4 ohms primary resistance.