Curt Trailer Hitch Installation Instructions at Amelia Cunningham blog

Curt Trailer Hitch Installation Instructions. Install a spacer onto the coiled end, and then thread the bolt onto the coil. Raise hitch into position and secure with (6) 7/16 flange nuts (3) on each side. Step 1 lower the spare tire from the inside of the vehicle by using the tools under the storage compartment. Place the flat edge of a pry. Using a 5/8 open end wrench, slide the wrench up to the rubber isolator, vehicle frame cradling the hanger rod as shown. Using pliers, remove (2) heat shield vehicle studs (1) on each side. Fishwire 7/16 carriage bolts (#1) into place through the hole in the side plate and out the bottom of the frame rail. Tabs into the frame rail. Remove the factory hitch and return to the owner. Raise hitch into position and loosely secure with 3/4 bolt followed by 1/2 flange nuts. Step 2 weldnut cleaning may be.

Remove the factory hitch and return to the owner. Raise hitch into position and secure with (6) 7/16 flange nuts (3) on each side. Raise hitch into position and loosely secure with 3/4 bolt followed by 1/2 flange nuts. Using a 5/8 open end wrench, slide the wrench up to the rubber isolator, vehicle frame cradling the hanger rod as shown. Install a spacer onto the coiled end, and then thread the bolt onto the coil. Step 1 lower the spare tire from the inside of the vehicle by using the tools under the storage compartment. Tabs into the frame rail. Fishwire 7/16 carriage bolts (#1) into place through the hole in the side plate and out the bottom of the frame rail. Place the flat edge of a pry. Step 2 weldnut cleaning may be.

CURT Trailer Hitch Installation Guide

Curt Trailer Hitch Installation Instructions Using a 5/8 open end wrench, slide the wrench up to the rubber isolator, vehicle frame cradling the hanger rod as shown. Step 1 lower the spare tire from the inside of the vehicle by using the tools under the storage compartment. Using pliers, remove (2) heat shield vehicle studs (1) on each side. Install a spacer onto the coiled end, and then thread the bolt onto the coil. Raise hitch into position and loosely secure with 3/4 bolt followed by 1/2 flange nuts. Fishwire 7/16 carriage bolts (#1) into place through the hole in the side plate and out the bottom of the frame rail. Place the flat edge of a pry. Tabs into the frame rail. Step 2 weldnut cleaning may be. Using a 5/8 open end wrench, slide the wrench up to the rubber isolator, vehicle frame cradling the hanger rod as shown. Remove the factory hitch and return to the owner. Raise hitch into position and secure with (6) 7/16 flange nuts (3) on each side.