How To Hook Up A Keg Tap at Joel Kates blog

How To Hook Up A Keg Tap. Insert the tap into the opening at the top of the keg. Continue turning until it stops, which is usually when the handle is at 90 degrees. It also shows you how to set the pressure of. Follow the instructions below for a smooth setup: Remove the cap, slide the. Place the coupler above the keg valve. To learn how to tap a keg with a party pump, follow these simple instructions: Insert the keg coupler into the locking neck of the beer keg and turn clockwise 25° to lock in into place. Align the coupler lugs with the openings at the top of the keg and press the coupler down until it fits inside the neck of the keg. Now the keg coupler is secured to the keg. Turn the pump, usually about 90 degrees, until it locks. To connect the keg coupler (10) to the keg (17), first make sure the black pull handle of the keg coupler is in the closed (diagonal/upper) position. Once the keg is prepared, it’s time to connect the tap system. Make sure the notches are lined up and push the tap in. Locate the beer line coming out of the.

Insert the tap into the opening at the top of the keg. Locate the beer line coming out of the. Follow the instructions below for a smooth setup: Continue turning until it stops, which is usually when the handle is at 90 degrees. Line up the lugs and begin screwing down the tap. Turn the tap clockwise until it. Place the coupler above the keg valve. You will need to apply downward pressure while turning the tap system clockwise. Insert the keg coupler into the locking neck of the beer keg and turn clockwise 25° to lock in into place. Align the coupler lugs with the openings at the top of the keg and press the coupler down until it fits inside the neck of the keg.

3 Ways to Change a Keg wikiHow

How To Hook Up A Keg Tap Turn the tap clockwise until it. To connect the keg coupler (10) to the keg (17), first make sure the black pull handle of the keg coupler is in the closed (diagonal/upper) position. Remove the cap, slide the. Turn the pump, usually about 90 degrees, until it locks. Make sure the notches are lined up and push the tap in. Locate the coupler on the keg (usually protected by a metal cap). Line up the lugs and begin screwing down the tap. Insert the tap into the opening at the top of the keg. You will need to apply downward pressure while turning the tap system clockwise. Continue turning until it stops, which is usually when the handle is at 90 degrees. Now the keg coupler is secured to the keg. Do not lower the lever! Place the coupler above the keg valve. Turn the tap clockwise until it. Insert the keg coupler into the locking neck of the beer keg and turn clockwise 25° to lock in into place. Follow the instructions below for a smooth setup: