Psp Umd Not Working at Pamela Schoenfeld blog

Psp Umd Not Working. You did replaced the umd drive, but. Removing the switch left very little to work off but luckily there are few components nearby so it is doable. If the umd is not properly inserted, it will not read. Use the psp opening tools to push the black tabs on the connector horizantally to free the cable. Doing so will damage the connector and/or ribbon cable. The pin could be bent or completely missing, but it’s instead likely a umd lever. Carefully disconnect the umd drive ribbon cable from the logic board. Did you replaced that one as well? This connector cannot be removed vertically. It's probably the worm motor which stopped working. But the laser turns on and the optics pulse up/down, so that's a good start. There's a lot that can go wrong on the umd drives. Check that the umd is properly inserted (label is facing the system rear). Bridged the umd detector pads with solder and a tiny bit of wire. You have to compress both the black umd lever and the black pin at the top right corner of the umd compartment.

Doing so will damage the connector and/or ribbon cable. This connector cannot be removed vertically. Use the psp opening tools to push the black tabs on the connector horizantally to free the cable. Carefully disconnect the umd drive ribbon cable from the logic board. Check that the umd is properly inserted (label is facing the system rear). Removing the switch left very little to work off but luckily there are few components nearby so it is doable. But the laser turns on and the optics pulse up/down, so that's a good start. There's a lot that can go wrong on the umd drives. Try taking out the umd and. You have to compress both the black umd lever and the black pin at the top right corner of the umd compartment.

Psp 1000 UMD Reader Not working r/PSP

Psp Umd Not Working Carefully disconnect the umd drive ribbon cable from the logic board. There's a lot that can go wrong on the umd drives. This connector cannot be removed vertically. Bridged the umd detector pads with solder and a tiny bit of wire. Try taking out the umd and. Carefully disconnect the umd drive ribbon cable from the logic board. But the laser turns on and the optics pulse up/down, so that's a good start. You have to compress both the black umd lever and the black pin at the top right corner of the umd compartment. Removing the switch left very little to work off but luckily there are few components nearby so it is doable. It's probably the worm motor which stopped working. Doing so will damage the connector and/or ribbon cable. Use the psp opening tools to push the black tabs on the connector horizantally to free the cable. The pin could be bent or completely missing, but it’s instead likely a umd lever. Did you replaced that one as well? If the umd is not properly inserted, it will not read. Check that the umd is properly inserted (label is facing the system rear).