Ski Doo Clutch Bolt Torque at Pam Galvez blog

Ski Doo Clutch Bolt Torque. I set it at 65 ft/lbs but thought i better ask to be safe. Just looking for the torque spec on the big bolt for the primary. Once reassemble my primary clutch, i need to properly torque the bolt holding it to the motor. Lbs for primary bolt (torque to 80 ft. Lbs then run the motor through. I would like to know the torque spec for the bolt that holds primary clutch on, from a 2007 summit 800. The book for my 07 gade states to lift the back end, this is after initial torque, run the sled to 20 m.p.h. Pretty sure he miss spoke for the torque specs because i just torqued to not even 18 ft/lbs and it snapped the head of the bolt. As a good example, look in any of the shop manuals for the maximum torque to be applied to the clutch puller. Anyone know the torque setting. Problem with the procedure in the shop manual is that it doesn't always work with the rear on the stand.

Anyone know the torque setting. Pretty sure he miss spoke for the torque specs because i just torqued to not even 18 ft/lbs and it snapped the head of the bolt. The book for my 07 gade states to lift the back end, this is after initial torque, run the sled to 20 m.p.h. Problem with the procedure in the shop manual is that it doesn't always work with the rear on the stand. I would like to know the torque spec for the bolt that holds primary clutch on, from a 2007 summit 800. Lbs for primary bolt (torque to 80 ft. Just looking for the torque spec on the big bolt for the primary. Lbs then run the motor through. I set it at 65 ft/lbs but thought i better ask to be safe. Once reassemble my primary clutch, i need to properly torque the bolt holding it to the motor.

9 tower clutch torque chart? Arctic Chat Arctic Cat Forum

Ski Doo Clutch Bolt Torque Once reassemble my primary clutch, i need to properly torque the bolt holding it to the motor. Once reassemble my primary clutch, i need to properly torque the bolt holding it to the motor. Just looking for the torque spec on the big bolt for the primary. Lbs for primary bolt (torque to 80 ft. I would like to know the torque spec for the bolt that holds primary clutch on, from a 2007 summit 800. I set it at 65 ft/lbs but thought i better ask to be safe. Lbs then run the motor through. Pretty sure he miss spoke for the torque specs because i just torqued to not even 18 ft/lbs and it snapped the head of the bolt. The book for my 07 gade states to lift the back end, this is after initial torque, run the sled to 20 m.p.h. Anyone know the torque setting. Problem with the procedure in the shop manual is that it doesn't always work with the rear on the stand. As a good example, look in any of the shop manuals for the maximum torque to be applied to the clutch puller.