Clear Coat Vht Nightshades at Madeleine Pardey blog

Clear Coat Vht Nightshades. 1m+ visitors in the past month 1m+ visitors in the past month I removed the tape and then gave the brake light and reverse light section that was taped a light sanding and also knocked down the paint edge. Clear coat them three coates before the nightshade dries, gives it a better finish. I however did not use clear. But if you must clear coat it, wait until the niteshades is completely dry and apply several medium wet coats of clear. Depends on the look you want. Clear coat runs and dirt in the clear can be wet sanded out. Clean off the tail lights to make sure no lingering brake fluid can drip onto your paint. When wet sanding always keep the sand paper and what ever your sanding. If you want gloss black, add clear coat (the more coats, the shinier they become). I clear coated the entire light so i wouldn’t have a paint edge. Open your trunk or hatch depending on your trim line. Put the tail lights back on and. 185k views 12 years ago.

When wet sanding always keep the sand paper and what ever your sanding. But if you must clear coat it, wait until the niteshades is completely dry and apply several medium wet coats of clear. I clear coated the entire light so i wouldn’t have a paint edge. Reach in and remove the wing nuts to the tails, and the screws on the sides for the hatch focus. 1m+ visitors in the past month Clean off the tail lights to make sure no lingering brake fluid can drip onto your paint. If you’re okay with a possible edge, then leave the tape and start clear coating. Open your trunk or hatch depending on your trim line. Clear coat runs and dirt in the clear can be wet sanded out. I however did not use clear.

HowTo Clear Coat Over VHT Nightshades YouTube

Clear Coat Vht Nightshades Reach in and remove the wing nuts to the tails, and the screws on the sides for the hatch focus. I clear coated the entire light so i wouldn’t have a paint edge. 185k views 12 years ago. Open your trunk or hatch depending on your trim line. But if you must clear coat it, wait until the niteshades is completely dry and apply several medium wet coats of clear. I however did not use clear. Put the tail lights back on and. 1m+ visitors in the past month Clean off the tail lights to make sure no lingering brake fluid can drip onto your paint. Reach in and remove the wing nuts to the tails, and the screws on the sides for the hatch focus. If you want gloss black, add clear coat (the more coats, the shinier they become). I removed the tape and then gave the brake light and reverse light section that was taped a light sanding and also knocked down the paint edge. When wet sanding always keep the sand paper and what ever your sanding. Clear coat them three coates before the nightshade dries, gives it a better finish. Clear coat runs and dirt in the clear can be wet sanded out. Depends on the look you want.