Jeep 4.0 Intake Manifold Vacuum at George Benavidez blog

Jeep 4.0 Intake Manifold Vacuum. Does anyone know what part number the rubber elbow for this vacuum line on the 4.0 intake manifold is (see picture) and where i can buy a new one? I started with removing the. I looked up a diagram for the 4.0 vacuum lines, sprayed throttle body cleaner all along them, there was no change in engine idle. I'm not really sure what to do at this point other. Does anyone know where i can find a supply of elbows for the three (3) vacuum lines that attach to the side of the intake manifold? Are there any other vacuum lines. I ruled out the vacuum leak as i had recently smoke checked everything and already. Vacuum leak and improperly installed intake. I run 8 degrees initial advance with. The smaller to the right goes to the vacuum pump that splices into the a/c control at the pass firewall. My goal is a late model intake, stainless performance header with a full 2.25 stainless exhaust, larger injectors, and bored throttle body. I found the plastic vacuum line to the intake manifold and understand the other end of the teed line goes to a resovoir under the battery.

The smaller to the right goes to the vacuum pump that splices into the a/c control at the pass firewall. Vacuum leak and improperly installed intake. Are there any other vacuum lines. My goal is a late model intake, stainless performance header with a full 2.25 stainless exhaust, larger injectors, and bored throttle body. Does anyone know what part number the rubber elbow for this vacuum line on the 4.0 intake manifold is (see picture) and where i can buy a new one? I started with removing the. I'm not really sure what to do at this point other. Does anyone know where i can find a supply of elbows for the three (3) vacuum lines that attach to the side of the intake manifold? I looked up a diagram for the 4.0 vacuum lines, sprayed throttle body cleaner all along them, there was no change in engine idle. I run 8 degrees initial advance with.

Jeep 4.0 Intake Manifold Efi To Carburetor Adapter Kit

Jeep 4.0 Intake Manifold Vacuum Does anyone know where i can find a supply of elbows for the three (3) vacuum lines that attach to the side of the intake manifold? I looked up a diagram for the 4.0 vacuum lines, sprayed throttle body cleaner all along them, there was no change in engine idle. I started with removing the. I found the plastic vacuum line to the intake manifold and understand the other end of the teed line goes to a resovoir under the battery. I'm not really sure what to do at this point other. Does anyone know where i can find a supply of elbows for the three (3) vacuum lines that attach to the side of the intake manifold? I ruled out the vacuum leak as i had recently smoke checked everything and already. Vacuum leak and improperly installed intake. The smaller to the right goes to the vacuum pump that splices into the a/c control at the pass firewall. My goal is a late model intake, stainless performance header with a full 2.25 stainless exhaust, larger injectors, and bored throttle body. Does anyone know what part number the rubber elbow for this vacuum line on the 4.0 intake manifold is (see picture) and where i can buy a new one? Are there any other vacuum lines. I run 8 degrees initial advance with.