Heater Control Valve Cable Not Moving at Ronald Wray blog

Heater Control Valve Cable Not Moving. Has stopped blowing heat from the front vents. If the cable is not moving either it is seized, the valve is seized, the air mix motor is bad or the hvac control panel is not telling the. If one side is hot and the other is cold, the valve is closed and not allowing coolant flow. We have a 2004 model and we are unable to get the heat to come on, or the air, without going behind the engine and moving the. Check under the dash to see that nothing has got shoved up into the flap to keep it from moving or that the flap has not been. The center console working fine with hot air and adjusts. This is the cable that goes from the hvac blend door actuator (under the radio/hvac cluster) to the heater control valve (on the. Start by checking the temperature of the heater hose connected to the heater control valve. It looks like there's 2 cables involved to open and close the heater valve, the cable from the panel to the blend door under the glove box (i have no idea what that part is actually. I have a 2004 pilot. When i try to move the valve with the cable on it, it does not move at all. Tried some wd40 and tried to turn it with pliers but still didn't move.

Start by checking the temperature of the heater hose connected to the heater control valve. We have a 2004 model and we are unable to get the heat to come on, or the air, without going behind the engine and moving the. When i try to move the valve with the cable on it, it does not move at all. This is the cable that goes from the hvac blend door actuator (under the radio/hvac cluster) to the heater control valve (on the. It looks like there's 2 cables involved to open and close the heater valve, the cable from the panel to the blend door under the glove box (i have no idea what that part is actually. Has stopped blowing heat from the front vents. Check under the dash to see that nothing has got shoved up into the flap to keep it from moving or that the flap has not been. If one side is hot and the other is cold, the valve is closed and not allowing coolant flow. I have a 2004 pilot. If the cable is not moving either it is seized, the valve is seized, the air mix motor is bad or the hvac control panel is not telling the.

Cable Operated NonBypass Pull to Close Heater Valve 74004 by FOUR

Heater Control Valve Cable Not Moving Start by checking the temperature of the heater hose connected to the heater control valve. Tried some wd40 and tried to turn it with pliers but still didn't move. When i try to move the valve with the cable on it, it does not move at all. It looks like there's 2 cables involved to open and close the heater valve, the cable from the panel to the blend door under the glove box (i have no idea what that part is actually. If the cable is not moving either it is seized, the valve is seized, the air mix motor is bad or the hvac control panel is not telling the. The center console working fine with hot air and adjusts. This is the cable that goes from the hvac blend door actuator (under the radio/hvac cluster) to the heater control valve (on the. I have a 2004 pilot. Start by checking the temperature of the heater hose connected to the heater control valve. Check under the dash to see that nothing has got shoved up into the flap to keep it from moving or that the flap has not been. Has stopped blowing heat from the front vents. We have a 2004 model and we are unable to get the heat to come on, or the air, without going behind the engine and moving the. If one side is hot and the other is cold, the valve is closed and not allowing coolant flow.