Crafting a quarter ring, a unique and symbolically significant piece of jewelry, is a rewarding DIY project. This guide will walk you through the process, from gathering materials to polishing your finished ring. Let's dive in.

Understanding the Quarter Ring
![Making a Folded Coin Ring from a Quarter [JoelDare.com]](https://i.pinimg.com/originals/12/ef/27/12ef275b950d3e95f97419a2e3b9fabf.jpg)
A quarter ring, also known as a signet ring, is a type of ring with a flat face, often used to bear a family crest or monogram. The term "quarter" refers to the ring's circular bezel, which is typically a quarter of a circle. This guide will focus on creating a simple quarter ring with a flat face, perfect for engraving or setting a stone.
Materials Needed

- Sterling silver or another metal of your choice (around 10 grams)
- Ring mandrel (size 6-8 for a standard adult ring)
- Ring sizing mandrel
- Jeweler's saw with a fine blade
- File (coarse and fine grit)
- Tumbler with stainless steel shot
- Engraving tool (optional, for personalizing the ring)
- Polishing cloth
Designing Your Quarter Ring

Before you start, decide on the size of your ring and the design for the flat face. Sketch your design on paper, keeping in mind that the bezel should be a quarter circle. You can also use online tools to create and visualize your design.
Creating the Ring Blank
Start by cutting a strip of metal from your wire, using the jeweler's saw. The width of the strip will determine the width of your ring. For a standard adult ring, cut a strip around 1.5mm wide. File the ends of the strip smooth.

Wrap the strip around the ring mandrel, ensuring it fits snugly. Mark the point where the ends meet, then saw along this mark to create a clean break. File the ends smooth again.
Sizing the Ring
Wrap the ring blank around your finger, marking the point where it fits comfortably. Saw along this mark to size the ring. Use the ring sizing mandrel to ensure a perfect fit.

Shaping the Quarter Ring
Using the coarse file, carefully shape the ring blank into a D-shape. The flat face will be the top of the ring, and the curved side will be the bottom. Ensure the bezel is a quarter circle, as this will give your ring its unique look.




















Once you've achieved the basic shape, switch to the fine grit file to refine and smooth the ring. Be careful not to file too much metal, as this can weaken the ring.
Polishing Your Quarter Ring
Place your ring in the tumbler with stainless steel shot. Tumble for around 30 minutes to an hour, checking periodically to ensure the ring is polishing evenly. Once you're satisfied with the shine, remove the ring and clean it thoroughly.
Engraving Your Quarter Ring (Optional)
If you've chosen to personalize your ring, use the engraving tool to carefully inscribe your design onto the flat face. Be sure to hold the tool at a consistent angle to create even lines.
Congratulations! You've now created a unique and meaningful quarter ring. Wear it with pride, knowing you crafted it with your own hands.