Creating a well prop, also known as a well point or well screen, is a crucial step in ensuring the longevity and functionality of your well. A well prop helps to prevent sediment and debris from clogging your pump and keeps your water supply clean and clear. In this guide, we'll walk you through the process of making a well prop, from gathering materials to installation.

Understanding Well Props

Before we dive into the DIY process, let's briefly understand what well props are and why they're important. A well prop is a protective barrier that sits at the bottom of your well, just above the aquifer. It's designed to allow water to flow into your well while preventing sediment and other contaminants from entering. Without a well prop, your well could become clogged with debris, leading to reduced water flow and potentially costly repairs.
Materials Needed

Making a well prop requires a few simple materials that you can find at your local hardware store. Here's a list of what you'll need:
- Schedule 40 PVC pipe (1.5 to 2 inches in diameter)
- PVC end cap
- PVC cement and primer
- PVC pipe cutter or hacksaw
- Well point screen (stainless steel or PVC with slots)
- Tape measure
- Marker
- Gravel (for backfilling)

Step-by-Step Guide to Making a Well Prop
1. Measure and Cut the PVC Pipe
First, you need to determine the length of your well prop. It should be long enough to reach from the bottom of your well to about 12 inches above the aquifer. Once you've measured the length, use a PVC pipe cutter or hacksaw to cut the pipe to size.

2. Attach the End Cap
Using PVC cement and primer, attach an end cap to one end of the PVC pipe. This will prevent sediment from entering the pipe from the bottom. Make sure to apply the cement and primer evenly and allow it to dry according to the manufacturer's instructions.
3. Install the Well Point Screen

The well point screen is the most critical component of your well prop. It allows water to flow into the pipe while keeping out sediment and other contaminants. To install the screen, you'll need to cut a slot in the PVC pipe that matches the size of the screen. Use a hacksaw or a PVC pipe cutter to make the cut. Then, slide the screen into place and secure it with PVC cement and primer.
4. Test the Well Prop




















Before installing your well prop, it's a good idea to test it to make sure it's working properly. You can do this by filling a bucket with water and submerging the well prop in the bucket. If water flows into the pipe, your well prop is ready for installation.
Installing the Well Prop
Now that you've made your well prop, it's time to install it in your well. Here are the steps to follow:
- Lower the well prop into the well using a rope or a well rope and weight system. Make sure the screened end is facing down and the end cap is at the top.
- Once the well prop is in place, backfill the area around it with gravel. This will help to stabilize the prop and prevent sediment from building up around it.
- Allow the gravel to settle for a few hours, then add more gravel if necessary to completely fill the space around the well prop.
- Finally, remove the rope or well rope and weight system, and your well prop is installed and ready to protect your well from sediment and debris.
Making and installing a well prop is a relatively simple process that can save you a lot of money in the long run. By keeping your well clean and clear, a well prop can extend the life of your well and ensure that you have a reliable source of clean water. If you have any questions or concerns about making or installing a well prop, don't hesitate to consult a professional well driller or pump installer.