Sharpening a tomahawk is a crucial skill for anyone who uses these versatile tools. Whether you're a survivalist, a bushcrafter, or a collector, keeping your tomahawk sharp ensures its effectiveness and longevity. This guide will walk you through the process, from understanding your tomahawk's edge to the final honing steps.

Understanding Your Tomahawk's Edge

Before you begin, it's essential to understand the type of edge your tomahawk has. Most tomahawks have a primary bevel and a secondary bevel. The primary bevel is the main cutting edge, while the secondary bevel is the grind that transitions into the spine. Knowing this will help you maintain the correct angle while sharpening.
Gather Your Sharpening Tools

To sharpen your tomahawk, you'll need a few tools. Here's a list of what you'll need:
- Sharpening stone (oil, water, or diamond stone)
- Sharpening guide (optional, but helpful for maintaining the correct angle)
- Compass or protractor (to measure the bevel angle)
- Honing compound (optional, for final honing)
- Towel or rag (to wipe off excess oil or water)

Determine the Bevel Angle
The bevel angle is the angle at which the blade meets the spine. Most tomahawks have a bevel angle between 20 and 30 degrees. To find the bevel angle of your tomahawk, use a compass or protractor to measure the angle of the primary bevel. This will help you maintain the correct angle while sharpening.
Pre-Sharpening: Removing the Burr

Before you start sharpening, you'll need to remove any burrs or nicks from the edge. A burr is a small, sharp edge that forms when the metal is deformed. To remove the burr, hold the tomahawk by the handle and run the edge along a flat, hard surface, like a piece of granite or a sharpening rod. This will break off the burr and prepare the edge for sharpening.
Sharpening the Tomahawk
Now that you've removed the burr, it's time to start sharpening. Place your sharpening stone on a flat surface and apply a few drops of oil, if using an oil stone. Hold the tomahawk by the handle and place the edge against the stone at the correct bevel angle. Using long, smooth strokes, sharpen the edge from the spine to the tip. Apply even pressure throughout the stroke.

Sharpen both sides of the primary bevel, maintaining the correct angle. It's a good idea to use a sharpening guide to help maintain the correct angle. If you don't have a sharpening guide, you can use a piece of tape on the stone to mark the angle.
Honing the Edge




















After you've sharpened the edge, it's time to hone it. Honing is the process of refining the edge to make it sharper. You can use a honing compound or a fine-grit stone for this step. Apply a small amount of honing compound to the stone and hold the tomahawk at the correct bevel angle. Using light pressure, stroke the edge along the stone from the spine to the tip.
Honing should be done in one direction only, unlike sharpening, which is done in both directions. After honing, wipe the edge with a towel or rag to remove any excess oil or honing compound.
Testing the Edge
To test the sharpness of your tomahawk, try cutting a piece of paper or a thin piece of rope. If the edge is sharp, it should cut easily. If not, you may need to sharpen and hone it a few more times.
Maintaining the Edge
To maintain the edge of your tomahawk, store it in a dry place and avoid using it on hard surfaces, like concrete or rock. If you do use it on hard surfaces, make sure to sharpen and hone it regularly.
Sharpening a tomahawk is a skill that improves with practice. With a little patience and the right tools, you can keep your tomahawk sharp and ready for use. Happy sharpening!