Understanding and Bypassing the Kenmore 80 Series Washer Lid Switch

If your Kenmore 80 series washer is displaying an error or refusing to operate due to a lid switch issue, you're not alone. The lid switch is a crucial component that ensures the washer's safety and proper functioning. In this guide, we'll delve into the role of the lid switch, common problems, and provide a step-by-step process to bypass it when necessary.

What is the Lid Switch and its Role?
The lid switch on your Kenmore 80 series washer is a safety feature that prevents the washer from operating unless the lid is securely closed. It's a simple yet essential component that consists of a switch and a lever. When the washer lid is closed, the lever presses down on the switch, completing the electrical circuit and allowing the washer to function.

Common Kenmore 80 Series Washer Lid Switch Issues
- Stuck in the closed position: The lid switch may remain in the closed position even when the lid is open, preventing the washer from operating.
- Stuck in the open position: Conversely, the switch might stay in the open position, even with the lid closed, also preventing the washer from functioning.
- Worn-out contacts: Over time, the contacts within the switch can wear out, causing intermittent or complete failure of the switch.

Diagnosing the Lid Switch Issue
Before attempting to bypass the lid switch, it's essential to diagnose the problem accurately. Here's a simple test:
- Unplug the washer from the power source.
- Locate the lid switch (consult your Kenmore 80 series washer's manual if needed).
- Using a multimeter set to continuity mode, test the switch. With the lid closed, there should be continuity (the multimeter beeps or shows a low resistance reading). With the lid open, there should be no continuity (no beep or high resistance reading).

Bypassing the Kenmore 80 Series Washer Lid Switch
Bypassing the lid switch should only be done as a temporary measure or when replacing the switch is not an option. Always ensure the washer is unplugged before proceeding.
- Locate the lid switch wires. They are usually connected to the washer's control board.
- Carefully disconnect the wires from the switch.
- Using electrical tape or a wire connector, join the two wires together. This creates a closed circuit, mimicking the lid switch's closed position.
- Plug the washer back in and test it. The washer should now operate with the lid open.

Safety Warning
Bypassing the lid switch disables a crucial safety feature. Never leave the washer unattended while operating with the lid open. Always ensure the washer is empty and unplugged when not in use.




















When to Replace the Lid Switch
If the lid switch is the cause of your Kenmore 80 series washer's issues, it's best to replace it rather than bypassing it. Replacement switches are readily available and the process is relatively straightforward. Always consult your washer's manual for specific instructions.