Is your LG WM2101HW washing machine not draining properly? The issue might be with the drain pump. This component plays a crucial role in removing water from your machine after the wash cycle. If it's faulty, it can cause water to remain in the tub or overflow, leading to potential damage and inconvenience. Here's a comprehensive guide on how to replace the drain pump in your LG WM2101HW, ensuring your appliance runs smoothly again.

Understanding the Drain Pump

The drain pump in your LG WM2101HW is located at the bottom front of the machine. It's responsible for pumping out water from the tub through the drain hose. When this part fails, it can cause water to back up in the machine, leading to various issues. Before you proceed with the replacement, ensure that the drain hose is not kinked or clogged, as this could also cause drainage problems.
Safety First: Preparing for the Replacement

Before you begin, ensure you've taken the necessary safety precautions:
- Unplug the washing machine from the power source.
- Turn off the water supply valves located behind the machine.
- Spread a towel or place a pan underneath the machine to catch any residual water.

Gathering the Required Tools
To replace the drain pump, you'll need the following tools:
- A Phillips #2 screwdriver
- Needle-nose pliers
- Adjustable wrench
- New drain pump (part number WP21012001)

Removing the Old Drain Pump
Now that you've gathered your tools and prepared the machine, you can begin removing the old drain pump:
- Remove the screws securing the lower access panel at the bottom front of the machine. Pull the panel off.
- Locate the drain pump. It's a small, circular component with a hose connected to it.
- Using needle-nose pliers, carefully disconnect the wire harness from the pump.
- Using an adjustable wrench, loosen and remove the hose clamp securing the drain hose to the pump.
- Pull the drain hose off the pump. Be prepared for some water to spill out.
- Remove the screws securing the pump to the machine. Pull the pump out.

Installing the New Drain Pump
Now that the old pump is out, you can install the new one:




















- Position the new drain pump in place. Ensure the arrow on the pump points towards the front of the machine.
- Secure the pump with the screws you removed earlier.
- Reattach the drain hose to the pump. Ensure the hose is securely fastened with the hose clamp.
- Reconnect the wire harness to the pump.
- Replace the lower access panel and secure it with the screws.
Testing the New Drain Pump
Before you turn the machine back on, perform a quick test to ensure the new drain pump is working:
- Plug the machine back in and turn on the water supply valves.
- Run a test cycle with hot water. The machine should drain properly.
If the machine drains correctly, you've successfully replaced the drain pump in your LG WM2101HW. If not, double-check that all connections are secure and the new pump is functioning correctly. Always remember to test your machine after performing any repairs to ensure it's working as it should.