Replacing Your Water Filter on a Whirlpool Refrigerator: A Step-by-Step Guide

Keeping your Whirlpool refrigerator's water filter up-to-date is crucial for ensuring clean, fresh water and ice. This guide will walk you through the process of replacing your water filter, step by step.

Understanding Your Whirlpool Refrigerator's Water Filter
Whirlpool refrigerators use a filter called the EveryDrop™ water filter. It's designed to reduce contaminants like chlorine, lead, and mercury, among others. The filter should be replaced every 6 months or 200 gallons, whichever comes first.
![Do Whirlpool Refrigerators Have Water Filters? [And When To Replace Them]](https://i.pinimg.com/originals/1e/c6/a5/1ec6a5a8671f9ea796d561d7e9508265.png)
Preparation: Gather Your Tools
Before you start, make sure you have the following tools and materials:

- A new EveryDrop™ water filter (ensure it's compatible with your refrigerator model)
- A flathead screwdriver
- A cup or bowl to catch any water drips
Step 1: Locate the Filter Housing
The filter housing is usually located behind the bottom, right-hand corner of the fresh food compartment. It may be covered by a panel. If so, use your flathead screwdriver to carefully remove it.

Step 2: Release the Filter
Turn the filter housing cap counterclockwise to release the filter. You may need to use some force, but be careful not to damage the cap. Once released, pull the filter out.
Step 3: Prepare the New Filter

Before installing the new filter, make sure to activate it. First, remove the protective cap from one end of the filter. Then, hold the filter under cold, running water for about 5 seconds to rinse it.
Step 4: Install the New Filter



















Insert the new filter into the filter housing, making sure the arrow on the filter points towards the front of the refrigerator. Turn the filter clockwise until it's tight, but be careful not to overtighten.
Step 5: Reset the Filter Indicator Light
After installing the new filter, you'll need to reset the filter indicator light. Consult your refrigerator's owner's manual for the exact process, as it varies by model. Typically, you'll need to press and hold the light for a few seconds until it turns off, then release and press again until it turns on.
Step 6: Test the Filter
Before using your refrigerator's water and ice dispenser, run some water through the filter to ensure it's working properly. Discard the first few gallons of water, as it may contain some residual charcoal dust.
Congratulations! You've successfully replaced the water filter on your Whirlpool refrigerator. Regularly replacing your filter will ensure that your water and ice remain fresh and clean. If you have any further questions or encounter any issues, don't hesitate to consult your refrigerator's owner's manual or contact Whirlpool's customer support.