Adjusting Throttle Cable On Evinrude Outboard at Dorothy Roof blog

Adjusting Throttle Cable On Evinrude Outboard. When all is as it should be, the proper method to adjust the shift cable is to disconnect the cable from the engine. You may also need to adjust. Secure cable, and reconnect to shift linkage. Adjust the trunion on the threaded portion of the shift cable so that the centered play of the cable lines up with the centered play of the engine’s. You probably need to adjust the cable to make sure it is pulling the linkage tight against the screw. Now shift it manually into forward and reverse. Adjust until cable matches shift linkage (once it matches, stop adjusting). This video shows how the shifter cable coming from an evinrude / johnson / omc controller actually changes gears. If the linkage is ok, center the end of the cable over the pin by adjusting that trunion. I replaced the cam roller and adjusted the throttle cable to the proper position at idle. I was showing 0.48v at idle and 4.4v at wot without making any tps linkage adjustments.

I replaced the cam roller and adjusted the throttle cable to the proper position at idle. This video shows how the shifter cable coming from an evinrude / johnson / omc controller actually changes gears. Adjust the trunion on the threaded portion of the shift cable so that the centered play of the cable lines up with the centered play of the engine’s. If the linkage is ok, center the end of the cable over the pin by adjusting that trunion. You probably need to adjust the cable to make sure it is pulling the linkage tight against the screw. When all is as it should be, the proper method to adjust the shift cable is to disconnect the cable from the engine. Secure cable, and reconnect to shift linkage. Now shift it manually into forward and reverse. Adjust until cable matches shift linkage (once it matches, stop adjusting). You may also need to adjust.

Mercury Outboard Throttle Linkage Diagram

Adjusting Throttle Cable On Evinrude Outboard I replaced the cam roller and adjusted the throttle cable to the proper position at idle. You probably need to adjust the cable to make sure it is pulling the linkage tight against the screw. Now shift it manually into forward and reverse. I replaced the cam roller and adjusted the throttle cable to the proper position at idle. Adjust until cable matches shift linkage (once it matches, stop adjusting). If the linkage is ok, center the end of the cable over the pin by adjusting that trunion. This video shows how the shifter cable coming from an evinrude / johnson / omc controller actually changes gears. Adjust the trunion on the threaded portion of the shift cable so that the centered play of the cable lines up with the centered play of the engine’s. Secure cable, and reconnect to shift linkage. I was showing 0.48v at idle and 4.4v at wot without making any tps linkage adjustments. When all is as it should be, the proper method to adjust the shift cable is to disconnect the cable from the engine. You may also need to adjust.