Servos Not Working In Inav at Olivia Madigan blog

Servos Not Working In Inav. I have a receiver bound and inputs showing on receiver page. Everything works well, excepted one thing. I just got a matek f411 wing flight controller in the mail this morning, and it's been almost 6 hours that i work on my flying wing project. I am trying to configure a speedybee f405 wing card on a flying wing. I have tried inav 6 and 6.1 and i still have the same. When i set this up and inav chose dshot 600 as the default, i was a little skeptical but figured if inav chose it, it should work ok. When i have tried to get the servos to work, i have the pm07 connected to a 2 cell lipo (the electronics are not installed in a plane yet), and i am able to connect to the pixhawk. In inav, i have enable the servos and motor and i can see that the fc is responding to my stick movements correctly. Hi, this is my first time using a fc in a fixed wing build. I'm using inav 2.0.0 and an omnibus f4pro v2 clone flashed with ver 1.9.1. Inav mixer and servo tab not available. After countless google searches i have not found any useful tips.

Hi, this is my first time using a fc in a fixed wing build. Inav mixer and servo tab not available. When i set this up and inav chose dshot 600 as the default, i was a little skeptical but figured if inav chose it, it should work ok. I'm using inav 2.0.0 and an omnibus f4pro v2 clone flashed with ver 1.9.1. After countless google searches i have not found any useful tips. Everything works well, excepted one thing. When i have tried to get the servos to work, i have the pm07 connected to a 2 cell lipo (the electronics are not installed in a plane yet), and i am able to connect to the pixhawk. I am trying to configure a speedybee f405 wing card on a flying wing. In inav, i have enable the servos and motor and i can see that the fc is responding to my stick movements correctly. I have a receiver bound and inputs showing on receiver page.

Servos/Motors wont move! · iNavFlight inav · Discussion 9015 · GitHub

Servos Not Working In Inav When i set this up and inav chose dshot 600 as the default, i was a little skeptical but figured if inav chose it, it should work ok. I have tried inav 6 and 6.1 and i still have the same. I'm using inav 2.0.0 and an omnibus f4pro v2 clone flashed with ver 1.9.1. I just got a matek f411 wing flight controller in the mail this morning, and it's been almost 6 hours that i work on my flying wing project. I am trying to configure a speedybee f405 wing card on a flying wing. In inav, i have enable the servos and motor and i can see that the fc is responding to my stick movements correctly. After countless google searches i have not found any useful tips. Hi, this is my first time using a fc in a fixed wing build. When i set this up and inav chose dshot 600 as the default, i was a little skeptical but figured if inav chose it, it should work ok. When i have tried to get the servos to work, i have the pm07 connected to a 2 cell lipo (the electronics are not installed in a plane yet), and i am able to connect to the pixhawk. I have a receiver bound and inputs showing on receiver page. Inav mixer and servo tab not available. Everything works well, excepted one thing.