Cj2A Axle Shims at Tara Kerns blog

Cj2A Axle Shims. The original setting for cj2a's is 1.5°. Shims, bearing retainer, backing plate, thin. If all shims are removed and adequate preload is still not obtained, a. Remove or add shims to obtain a preload within these limits. The shims were.070 right and.080 left and they were replaced as originally found. I have a question on the rear axle shims on my 1948 cj2a.i am putting on 11 brake drums and when i removed the 9 drums i took off the. If larger tires are installed on the rear than on the front, the. The shims are bigger than the bearing cone so that allows the bearing cone to stick out as the backing plate pushes the cone in place. I packed the wheel bearings prior to. The caster angle is very important. I am rebuilding a 2a rear axle, and i'm trying to figure out the best way to measure the endplay. Obviously when the shims and bearing retainer. When assembling the rear axle backing plate, we arranged all the parts in the correct order from left to right top, then left to right bottom:

I packed the wheel bearings prior to. Shims, bearing retainer, backing plate, thin. The original setting for cj2a's is 1.5°. The shims are bigger than the bearing cone so that allows the bearing cone to stick out as the backing plate pushes the cone in place. When assembling the rear axle backing plate, we arranged all the parts in the correct order from left to right top, then left to right bottom: Obviously when the shims and bearing retainer. If all shims are removed and adequate preload is still not obtained, a. If larger tires are installed on the rear than on the front, the. I have a question on the rear axle shims on my 1948 cj2a.i am putting on 11 brake drums and when i removed the 9 drums i took off the. The shims were.070 right and.080 left and they were replaced as originally found.

Jeep Willys CJ2A M38 M38A1 CJ3A Dana 44 41 rear axle outer bearing shim

Cj2A Axle Shims Obviously when the shims and bearing retainer. If all shims are removed and adequate preload is still not obtained, a. The shims are bigger than the bearing cone so that allows the bearing cone to stick out as the backing plate pushes the cone in place. The caster angle is very important. I am rebuilding a 2a rear axle, and i'm trying to figure out the best way to measure the endplay. When assembling the rear axle backing plate, we arranged all the parts in the correct order from left to right top, then left to right bottom: Obviously when the shims and bearing retainer. Remove or add shims to obtain a preload within these limits. The shims were.070 right and.080 left and they were replaced as originally found. The original setting for cj2a's is 1.5°. I have a question on the rear axle shims on my 1948 cj2a.i am putting on 11 brake drums and when i removed the 9 drums i took off the. Shims, bearing retainer, backing plate, thin. I packed the wheel bearings prior to. If larger tires are installed on the rear than on the front, the.