Jeep Tj Stock Control Arm Length at Amparo Sharpe blog

Jeep Tj Stock Control Arm Length. I set them at 15.5 and then had my local shop install them. The important thing for lower length is that your bumpstops align and axle is. You have to take all of those things into account. According to the instructions, the arms should be 15.5 inches for the 4 lift. Dirk's recommended starting point for the ome lift arm lengths is the stock lengths, except for +5/16 on front lowers. The rc rep said 15.25. Does anyone actually use curries recommended control arm lengths for their tj with 4 lift and sye (yes the sye matters to you. No one knows what that is for your jeep except you. Control arms are used to set caster (in front), pinion angle and axle location front to rear. The correct control arm lengths are the lengths that they end up being after adjusting to put the axles where they need to be. Due to factory variations in control arm mounting locations, there is no set length and each jeep is different.

The important thing for lower length is that your bumpstops align and axle is. You have to take all of those things into account. The rc rep said 15.25. Does anyone actually use curries recommended control arm lengths for their tj with 4 lift and sye (yes the sye matters to you. No one knows what that is for your jeep except you. Dirk's recommended starting point for the ome lift arm lengths is the stock lengths, except for +5/16 on front lowers. Control arms are used to set caster (in front), pinion angle and axle location front to rear. According to the instructions, the arms should be 15.5 inches for the 4 lift. Due to factory variations in control arm mounting locations, there is no set length and each jeep is different. The correct control arm lengths are the lengths that they end up being after adjusting to put the axles where they need to be.

Jeep Xj Control Arm Length Chart

Jeep Tj Stock Control Arm Length The important thing for lower length is that your bumpstops align and axle is. The rc rep said 15.25. You have to take all of those things into account. No one knows what that is for your jeep except you. The correct control arm lengths are the lengths that they end up being after adjusting to put the axles where they need to be. Due to factory variations in control arm mounting locations, there is no set length and each jeep is different. Dirk's recommended starting point for the ome lift arm lengths is the stock lengths, except for +5/16 on front lowers. Does anyone actually use curries recommended control arm lengths for their tj with 4 lift and sye (yes the sye matters to you. Control arms are used to set caster (in front), pinion angle and axle location front to rear. According to the instructions, the arms should be 15.5 inches for the 4 lift. The important thing for lower length is that your bumpstops align and axle is. I set them at 15.5 and then had my local shop install them.