Bontrager Hub End Cap Removal at Peggy Bergmann blog

Bontrager Hub End Cap Removal. Pull off the nds end cap. Stick the appropriately sized hex wrench in the nds axle. If i understand correctly, there's cap that should come off first (that the thru axle goes through) and then the freehub should pull off easily. Remove the drive side outer nut (15mm). Position the completed end cap over the axle, and press into place with your fingers. Remove the cassette from the wheel. Using the 17mm or 15mm cone wrench or open end wrench, remove the ds end cap. The installation of the freehub is. Grab freehub and pull it away from hub body. Tap the axle (either end) with the hammer until the axle is flush with the surface of the end cap. Pull axle to the left and remove axle from hub. Remove the non drive side cones (15mm & 19mm) & spacers and lay. I can't get the cap off and i. After completing assembly of the hub, check its.

Tap the axle (either end) with the hammer until the axle is flush with the surface of the end cap. Remove the drive side outer nut (15mm). Stick the appropriately sized hex wrench in the nds axle. If i understand correctly, there's cap that should come off first (that the thru axle goes through) and then the freehub should pull off easily. Remove the cassette from the wheel. Position the completed end cap over the axle, and press into place with your fingers. The installation of the freehub is. Remove the non drive side cones (15mm & 19mm) & spacers and lay. Using the 17mm or 15mm cone wrench or open end wrench, remove the ds end cap. After completing assembly of the hub, check its.

Bontrager XDR 12mm Drive Side Axle End Cap Trek Bikes Vietnam

Bontrager Hub End Cap Removal Position the completed end cap over the axle, and press into place with your fingers. Using the 17mm or 15mm cone wrench or open end wrench, remove the ds end cap. Remove the cassette from the wheel. Remove the drive side outer nut (15mm). Tap the axle (either end) with the hammer until the axle is flush with the surface of the end cap. Position the completed end cap over the axle, and press into place with your fingers. Stick the appropriately sized hex wrench in the nds axle. After completing assembly of the hub, check its. Pull axle to the left and remove axle from hub. If i understand correctly, there's cap that should come off first (that the thru axle goes through) and then the freehub should pull off easily. Remove the non drive side cones (15mm & 19mm) & spacers and lay. Pull off the nds end cap. Grab freehub and pull it away from hub body. I can't get the cap off and i. The installation of the freehub is.