Clean Camshaft Before Install at James Browning blog

Clean Camshaft Before Install. As far as washing or not washing the cam, if you don't wash the cosmoline off it, there is no way you can get the molybdenum. Before installing the camshaft and lifters, wash them thoroughly in clean mineral spirits to remove the rust preventative that is placed on the cam. Access the engine’s camshaft, lifters and timing chain, rotate the crankshaft to align the timing marks. Years ago, i used to use stp oil treatment and a 1 inch paint brush with good results. Clean and lube the new cam before installation. Move it as far back as the plug at the rear of the block will allow, and fasten the upper timing gear. Avoid any paste or moly because that. Brake cleaner and wipe down with a shop towel. Then put on some isky rev lube or other cam lube and run in. Blow off with some compressed air to remove any shedded fibers. This video has some good information on how to clean and properly care for your camshaft for.

Then put on some isky rev lube or other cam lube and run in. Clean and lube the new cam before installation. Before installing the camshaft and lifters, wash them thoroughly in clean mineral spirits to remove the rust preventative that is placed on the cam. Avoid any paste or moly because that. Blow off with some compressed air to remove any shedded fibers. Access the engine’s camshaft, lifters and timing chain, rotate the crankshaft to align the timing marks. Move it as far back as the plug at the rear of the block will allow, and fasten the upper timing gear. This video has some good information on how to clean and properly care for your camshaft for. Years ago, i used to use stp oil treatment and a 1 inch paint brush with good results. As far as washing or not washing the cam, if you don't wash the cosmoline off it, there is no way you can get the molybdenum.

Camshaft Installation Small Block Chevy

Clean Camshaft Before Install Avoid any paste or moly because that. Brake cleaner and wipe down with a shop towel. Access the engine’s camshaft, lifters and timing chain, rotate the crankshaft to align the timing marks. As far as washing or not washing the cam, if you don't wash the cosmoline off it, there is no way you can get the molybdenum. Blow off with some compressed air to remove any shedded fibers. Clean and lube the new cam before installation. Then put on some isky rev lube or other cam lube and run in. This video has some good information on how to clean and properly care for your camshaft for. Years ago, i used to use stp oil treatment and a 1 inch paint brush with good results. Move it as far back as the plug at the rear of the block will allow, and fasten the upper timing gear. Avoid any paste or moly because that. Before installing the camshaft and lifters, wash them thoroughly in clean mineral spirits to remove the rust preventative that is placed on the cam.