Peterbilt Axle Nut Torque. Rotated counterclockwise against the retainer nut. These are the 15 /16 nuts that hold the axle in on the hub. Back the adjusting nut off one full turn. The main this is that these spindle nuts are not backed off. Gonna do brakes this weekend and my axle nuts are a little wet with oil. Some technicians even torque them more than what's indicated in. So i’m gonna pull it, clean the base up and permatex it. I'm putting the axles back in my 40,000 lb rears. • always torque fasteners and fuel connections to the required specifications. Use a hammer and staking tool to stake the stake. Most drive axle wheel hubs have a center axle nut that must be torqued down onto the axle shaft to a speciic torque value. The spacer inside sets the bearing preload. The nut may need to be slightly tightened or loosened to meet the required end play. What are they supposed to be torqued at?
from support.karavantrailers.com
Use a hammer and staking tool to stake the stake. These are the 15 /16 nuts that hold the axle in on the hub. I'm putting the axles back in my 40,000 lb rears. Rotated counterclockwise against the retainer nut. The nut may need to be slightly tightened or loosened to meet the required end play. The spacer inside sets the bearing preload. • always torque fasteners and fuel connections to the required specifications. What are they supposed to be torqued at? Most drive axle wheel hubs have a center axle nut that must be torqued down onto the axle shaft to a speciic torque value. Gonna do brakes this weekend and my axle nuts are a little wet with oil.
What is the torque spec for my tires? Karavan Trailers
Peterbilt Axle Nut Torque Some technicians even torque them more than what's indicated in. Most drive axle wheel hubs have a center axle nut that must be torqued down onto the axle shaft to a speciic torque value. What are they supposed to be torqued at? The nut may need to be slightly tightened or loosened to meet the required end play. The spacer inside sets the bearing preload. The main this is that these spindle nuts are not backed off. Back the adjusting nut off one full turn. • always torque fasteners and fuel connections to the required specifications. Some technicians even torque them more than what's indicated in. I'm putting the axles back in my 40,000 lb rears. Rotated counterclockwise against the retainer nut. These are the 15 /16 nuts that hold the axle in on the hub. Use a hammer and staking tool to stake the stake. So i’m gonna pull it, clean the base up and permatex it. Gonna do brakes this weekend and my axle nuts are a little wet with oil.