Audi Tt Flywheel Bolt Torque at Kermit Bourdon blog

Audi Tt Flywheel Bolt Torque. If 43 mm bolts then 60nm and. Well depending on where i look (bently, chiltons) i'm finding the torque spec. Understand your dilemma but it is very risky if you don't change them, how do you know what torque to tighten them to? What i mean by crossing sequence. 3) torque the flywheel and pressure plate bolts to the proper fl/lbs (44 for the flywheel and 18 for the pressure plate) and make sure. So, torque to 60nm, then turn all +90 in crossing sequence, then again +90 in crossing sequence? There were two sets of bolts and fly wheels for this engine. Replace bolts, torque to 60 nm + 90°. It the bolts were 22.5 mm the 60 nm and 90 degrees. For the 22.5mm bolts on my '00 atw 1.8t engine. Depending on the model there are 2 types of bolts identified by their length. I'm in the middle of putting my engine/trans back together and getting it in my car today.

There were two sets of bolts and fly wheels for this engine. What i mean by crossing sequence. Replace bolts, torque to 60 nm + 90°. Depending on the model there are 2 types of bolts identified by their length. For the 22.5mm bolts on my '00 atw 1.8t engine. So, torque to 60nm, then turn all +90 in crossing sequence, then again +90 in crossing sequence? Understand your dilemma but it is very risky if you don't change them, how do you know what torque to tighten them to? Well depending on where i look (bently, chiltons) i'm finding the torque spec. 3) torque the flywheel and pressure plate bolts to the proper fl/lbs (44 for the flywheel and 18 for the pressure plate) and make sure. It the bolts were 22.5 mm the 60 nm and 90 degrees.

Flywheel Bolt Torque Specs

Audi Tt Flywheel Bolt Torque It the bolts were 22.5 mm the 60 nm and 90 degrees. I'm in the middle of putting my engine/trans back together and getting it in my car today. There were two sets of bolts and fly wheels for this engine. Replace bolts, torque to 60 nm + 90°. What i mean by crossing sequence. 3) torque the flywheel and pressure plate bolts to the proper fl/lbs (44 for the flywheel and 18 for the pressure plate) and make sure. It the bolts were 22.5 mm the 60 nm and 90 degrees. So, torque to 60nm, then turn all +90 in crossing sequence, then again +90 in crossing sequence? For the 22.5mm bolts on my '00 atw 1.8t engine. If 43 mm bolts then 60nm and. Understand your dilemma but it is very risky if you don't change them, how do you know what torque to tighten them to? Depending on the model there are 2 types of bolts identified by their length. Well depending on where i look (bently, chiltons) i'm finding the torque spec.