E4Od Transmission Cooler Line Fitting Size at Malik Garcia blog

E4Od Transmission Cooler Line Fitting Size. The trans cooler fittings from a 4r100 take 3/8 lines and are a direct fit to an e4od. This means that the front fitting has fluid exiting, presumably under pressure. I need to know the male threaded size. You would be better off to change the lines to super duty lines from a 4r100. The rear fitting (on the e4od) is the cooler return line. The super duty lines are 3/8 rather than the. It says 3/8 pipe, but its definetely not 3/8 npt thread, since it is straight, not tapered. So when i hook up the v10 cooler it has threaded ends in the cooler and was wondering if i should use 1/2 inch lines to/from. And im looking for both the front and rear connection. Hello, on a 92 e4od what is the cooling fitting line size on the transmission case and steel line threaded coupler? You would need to either run the 4r100's. I also believe that fitting. If you remove the return line, you can check the ball by pushing on it with a screwdriver through the open port.

This means that the front fitting has fluid exiting, presumably under pressure. If you remove the return line, you can check the ball by pushing on it with a screwdriver through the open port. The super duty lines are 3/8 rather than the. And im looking for both the front and rear connection. I also believe that fitting. I need to know the male threaded size. You would need to either run the 4r100's. Hello, on a 92 e4od what is the cooling fitting line size on the transmission case and steel line threaded coupler? You would be better off to change the lines to super duty lines from a 4r100. So when i hook up the v10 cooler it has threaded ends in the cooler and was wondering if i should use 1/2 inch lines to/from.

VALVE KIT, COOLER BYPASS E4OD / 4R100 1989UP (SONNAX) PATC

E4Od Transmission Cooler Line Fitting Size It says 3/8 pipe, but its definetely not 3/8 npt thread, since it is straight, not tapered. It says 3/8 pipe, but its definetely not 3/8 npt thread, since it is straight, not tapered. Hello, on a 92 e4od what is the cooling fitting line size on the transmission case and steel line threaded coupler? The trans cooler fittings from a 4r100 take 3/8 lines and are a direct fit to an e4od. I need to know the male threaded size. So when i hook up the v10 cooler it has threaded ends in the cooler and was wondering if i should use 1/2 inch lines to/from. If you remove the return line, you can check the ball by pushing on it with a screwdriver through the open port. You would need to either run the 4r100's. The rear fitting (on the e4od) is the cooler return line. You would be better off to change the lines to super duty lines from a 4r100. I also believe that fitting. And im looking for both the front and rear connection. The super duty lines are 3/8 rather than the. This means that the front fitting has fluid exiting, presumably under pressure.