Tikka Firing Pin Problems at Joseph Becher blog

Tikka Firing Pin Problems. I would like to improve my firing pin and spring on my 6.5 cm. Put the original handle back in and see what happens. The new trigger spring shouldn't be an issue. Over the last couple of years i’ve done a lot. I’m using the bore buddy pin, dry firing with snap caps and drywall anchors, no problems with several thousand live rounds and. Want to up grade my spring/firing pin. After roughly 150 rds i disassembled to the bolt to inspect it and noticed two scratches. I have heard of some issues with the factory tikka t1x breaking the tip off of the firing pin. I recently purchased a new tikka t3x 7rm. I see that it rubs on the. The raised ring around the pin strike is the primer flowing into the bevel, and likely the firing pin tip isn't a tight fit in the hole. Might be a bolt handle issue.

I recently purchased a new tikka t3x 7rm. Want to up grade my spring/firing pin. Put the original handle back in and see what happens. Over the last couple of years i’ve done a lot. The raised ring around the pin strike is the primer flowing into the bevel, and likely the firing pin tip isn't a tight fit in the hole. I have heard of some issues with the factory tikka t1x breaking the tip off of the firing pin. I would like to improve my firing pin and spring on my 6.5 cm. I’m using the bore buddy pin, dry firing with snap caps and drywall anchors, no problems with several thousand live rounds and. I see that it rubs on the. After roughly 150 rds i disassembled to the bolt to inspect it and noticed two scratches.

Does your tikka bolt have these rough parallell lines? Found inside the

Tikka Firing Pin Problems After roughly 150 rds i disassembled to the bolt to inspect it and noticed two scratches. I see that it rubs on the. I would like to improve my firing pin and spring on my 6.5 cm. Over the last couple of years i’ve done a lot. The raised ring around the pin strike is the primer flowing into the bevel, and likely the firing pin tip isn't a tight fit in the hole. After roughly 150 rds i disassembled to the bolt to inspect it and noticed two scratches. The new trigger spring shouldn't be an issue. I have heard of some issues with the factory tikka t1x breaking the tip off of the firing pin. I recently purchased a new tikka t3x 7rm. Put the original handle back in and see what happens. Might be a bolt handle issue. Want to up grade my spring/firing pin. I’m using the bore buddy pin, dry firing with snap caps and drywall anchors, no problems with several thousand live rounds and.