Fuel Governor Adjustment at James Farris blog

Fuel Governor Adjustment. To adjust, remove the large plug on top of the afc housing using an 8 mm allen wrench. The fuel should be turned up through the side cover (pin on timing gear @10:00). The steps for turning up a p7100 pump are: 5) slide the afc housing all the way forward. Take care not to loose the sealing washer under the plug. 3406b fuel & torque screw adjustment. 4) crank the star wheel towards the motor. Removing the plug exposes a star wheel which changes the quickness of fueling response to boost. My fuel and torque screws seem to be adjusted so that when i push them both in. 2) mod your fuel plate either slide it forward or purchase a cut one. Adjust governor gap with the engine stopped and at normal operating temperature, adjust the governor gap as follows: 1) remove your afc housing. 3) adjust the governor lever to contact the fuel plate. Disconnect any linkage attached to the governor levers. In order to remove the governor rod assembly.

In order to remove the governor rod assembly. 3) adjust the governor lever to contact the fuel plate. 1) remove your afc housing. Disconnect any linkage attached to the governor levers. 3406b fuel & torque screw adjustment. The fuel should be turned up through the side cover (pin on timing gear @10:00). There are two separate adjustments that must be made to correctly set the booster spring to achieve mininum governor. My fuel and torque screws seem to be adjusted so that when i push them both in. The steps for turning up a p7100 pump are: 2) mod your fuel plate either slide it forward or purchase a cut one.

Generator Governor Adjustment YouTube

Fuel Governor Adjustment In order to remove the governor rod assembly. Removing the plug exposes a star wheel which changes the quickness of fueling response to boost. 3406b fuel & torque screw adjustment. 2) mod your fuel plate either slide it forward or purchase a cut one. 4) crank the star wheel towards the motor. Take care not to loose the sealing washer under the plug. Disconnect any linkage attached to the governor levers. In order to remove the governor rod assembly. The steps for turning up a p7100 pump are: 5) slide the afc housing all the way forward. The fuel should be turned up through the side cover (pin on timing gear @10:00). 3) adjust the governor lever to contact the fuel plate. To adjust, remove the large plug on top of the afc housing using an 8 mm allen wrench. There are two separate adjustments that must be made to correctly set the booster spring to achieve mininum governor. My fuel and torque screws seem to be adjusted so that when i push them both in. Adjust governor gap with the engine stopped and at normal operating temperature, adjust the governor gap as follows: