Jeep 4.0 Break In Procedure at Barbara Blackmon blog

Jeep 4.0 Break In Procedure. What do most people recommend for the break in period? I just had a rebuilt 4.0 installed in my 2002 wrangler x. I've been asked by a few members about showing what was involved in building a 4.0. The recommended break in procedure from the. This is my first new vehicle and my first jeep. The remanufacturer gave instructions to change the oil at 500 miles and. Soft and easy until the first oil change, or drive it like it is stolen? What is the best way to break in a new engine, and if it. • depress the accelerator pedal slowly and not more than halfway to avoid rapid acceleration. It will smoke at start up. Well 3 came in the shop last week, 2 are stock rebuilds and one is going to be a stroker. Two months ago my son and i installed a sure fire 4.0 long block in his '00 tj. The cam kits i install require 2000rpm for @20 minutes to break them and the flat lifters in correctly. I've got the 4.0 and the 6 speed.

What is the best way to break in a new engine, and if it. I've been asked by a few members about showing what was involved in building a 4.0. The cam kits i install require 2000rpm for @20 minutes to break them and the flat lifters in correctly. Soft and easy until the first oil change, or drive it like it is stolen? • depress the accelerator pedal slowly and not more than halfway to avoid rapid acceleration. This is my first new vehicle and my first jeep. Two months ago my son and i installed a sure fire 4.0 long block in his '00 tj. I just had a rebuilt 4.0 installed in my 2002 wrangler x. I've got the 4.0 and the 6 speed. Well 3 came in the shop last week, 2 are stock rebuilds and one is going to be a stroker.

Building a 10,000 RPM Jeep 4.0 Common Problems YouTube

Jeep 4.0 Break In Procedure Two months ago my son and i installed a sure fire 4.0 long block in his '00 tj. The recommended break in procedure from the. The remanufacturer gave instructions to change the oil at 500 miles and. • depress the accelerator pedal slowly and not more than halfway to avoid rapid acceleration. What is the best way to break in a new engine, and if it. Two months ago my son and i installed a sure fire 4.0 long block in his '00 tj. The cam kits i install require 2000rpm for @20 minutes to break them and the flat lifters in correctly. It will smoke at start up. Well 3 came in the shop last week, 2 are stock rebuilds and one is going to be a stroker. Soft and easy until the first oil change, or drive it like it is stolen? This is my first new vehicle and my first jeep. What do most people recommend for the break in period? I just had a rebuilt 4.0 installed in my 2002 wrangler x. I've got the 4.0 and the 6 speed. I've been asked by a few members about showing what was involved in building a 4.0.