Harley Pushrod Spin at Leland Apple blog

Harley Pushrod Spin. If after 20/30 minutes you can spin the pushrod with your fingers you do not have limited travel tappets (hl2t kit). Lock down the pushod and repeat. If you do not have hl2t or travel. The pushrod you are adjusting should be on the heel of the cam (in its lowest position); From this point you want to shorten one full turn, 6 flats. A discussion thread about how to adjust pushrods and lifters when installing new ones on a harley davidson engine. Make sure after adjusting a pushrod to let it sit until you can spin the rod with you fingers before turning the engine over. Before turning the engine over to adjust another valve, you have to be able to spin the pushrod of the last adjusted valve with your. The equal opposite pushrod will be at the high point. Lengthen the pushrod until valve is held open (putting pressure on piston in lifter) until it bleeds down completely and can not be turned. The pushrod must spin freely.

Before turning the engine over to adjust another valve, you have to be able to spin the pushrod of the last adjusted valve with your. Lengthen the pushrod until valve is held open (putting pressure on piston in lifter) until it bleeds down completely and can not be turned. A discussion thread about how to adjust pushrods and lifters when installing new ones on a harley davidson engine. The pushrod you are adjusting should be on the heel of the cam (in its lowest position); From this point you want to shorten one full turn, 6 flats. The equal opposite pushrod will be at the high point. Make sure after adjusting a pushrod to let it sit until you can spin the rod with you fingers before turning the engine over. Lock down the pushod and repeat. If you do not have hl2t or travel. If after 20/30 minutes you can spin the pushrod with your fingers you do not have limited travel tappets (hl2t kit).

Installing and adjusting S&S Quickee Pushrods on a Harley Davidson

Harley Pushrod Spin From this point you want to shorten one full turn, 6 flats. If after 20/30 minutes you can spin the pushrod with your fingers you do not have limited travel tappets (hl2t kit). Make sure after adjusting a pushrod to let it sit until you can spin the rod with you fingers before turning the engine over. The pushrod must spin freely. Before turning the engine over to adjust another valve, you have to be able to spin the pushrod of the last adjusted valve with your. From this point you want to shorten one full turn, 6 flats. If you do not have hl2t or travel. The equal opposite pushrod will be at the high point. Lock down the pushod and repeat. A discussion thread about how to adjust pushrods and lifters when installing new ones on a harley davidson engine. The pushrod you are adjusting should be on the heel of the cam (in its lowest position); Lengthen the pushrod until valve is held open (putting pressure on piston in lifter) until it bleeds down completely and can not be turned.