Zrt 600 Clutching at Myrtis White blog

Zrt 600 Clutching. Would engage the clutch at around 5500 and top out at around 9100 rpms. Took it all off and put it back to stock because it was too touchy. He was neck and neck with a stock zr800. I don't have the details of my setup typed out but i have different weights, springs, roller secondary,. It made a huge difference. This sled ran the best at 8500 rpm. I have a 96 zrt 600 all stock except for some picks. I have my 96 zrt motor in my sled. The key to agood running 1996 zrt 600 is the correct positioning, and proper sealing of the pipes. A buddy of mine put a d&d clutch kit in his zrt 600, and wow. I'm trying to learn about the clutches on my 96 zrt 600. If you pick up a comet clutch it looks like the recommended spring/weight combo is slightly different than the stock 9 tower. Wide open rpm is important when setting up clutching. I'm looking for advice on the best setup with stock components. Is it stock pipes or aftermarket pipes?

I'm looking for advice on the best setup with stock components. I don't have the details of my setup typed out but i have different weights, springs, roller secondary,. Is it stock pipes or aftermarket pipes? The key to agood running 1996 zrt 600 is the correct positioning, and proper sealing of the pipes. He was neck and neck with a stock zr800. I have my 96 zrt motor in my sled. Engine is fresh, carbs clean, new carb boots, 125pso compression cold. Took it all off and put it back to stock because it was too touchy. A buddy of mine put a d&d clutch kit in his zrt 600, and wow. Would engage the clutch at around 5500 and top out at around 9100 rpms.

Hi gentleman, dies anyone no a good clutch set up for a 97 zrt 600

Zrt 600 Clutching A buddy of mine put a d&d clutch kit in his zrt 600, and wow. The key to agood running 1996 zrt 600 is the correct positioning, and proper sealing of the pipes. Took it all off and put it back to stock because it was too touchy. I don't have the details of my setup typed out but i have different weights, springs, roller secondary,. I have my 96 zrt motor in my sled. I'm looking for advice on the best setup with stock components. I'm trying to learn about the clutches on my 96 zrt 600. I have a 96 zrt 600 all stock except for some picks. If you pick up a comet clutch it looks like the recommended spring/weight combo is slightly different than the stock 9 tower. Would engage the clutch at around 5500 and top out at around 9100 rpms. This sled ran the best at 8500 rpm. A buddy of mine put a d&d clutch kit in his zrt 600, and wow. Wide open rpm is important when setting up clutching. Is it stock pipes or aftermarket pipes? He was neck and neck with a stock zr800. It made a huge difference.